Scribd
Upload
287 views3 pages

Manual Valve Link Replacement: Removal Procedure

1. The document provides instructions for removing and installing the manual valve link on a 1998 Saturn SL2/SC2/SW2. 2. To remove it, the valve body and nut retaining the manual detent lever must first be removed, followed by removing the manual detent lever and link. 3. Installation is the reverse process, requiring reattaching the manual valve link to the lever, preventing shaft rotation, torquing the attachment nut, and reinstalling the valve body.

Uploaded by

lamping_ap
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
287 views3 pages

Manual Valve Link Replacement: Removal Procedure

1. The document provides instructions for removing and installing the manual valve link on a 1998 Saturn SL2/SC2/SW2. 2. To remove it, the valve body and nut retaining the manual detent lever must first be removed, followed by removing the manual detent lever and link. 3. Installation is the reverse process, requiring reattaching the manual valve link to the lever, preventing shaft rotation, torquing the attachment nut, and reinstalling the valve body.

Uploaded by

lamping_ap
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

<- Back Forward ->

Document ID# 881408


1998 Saturn SL2/SC2/SW2
Print
Manual Valve Link Replacement
Removal Procedure

1. Remove the valvebody. Refer to Control Valve Body Assembly Removal .
Notice
If manual shift shaft is rotated excessively, internal damage to the transaxle range switch may occur.
2. Remove the nut retaining the manual detent lever to the manual shift shaft.
Important
Place a clean rag in the transaxle case under the manual detent lever to catch the nut in case it is dropped.
3. Remove the manual detent lever from the manual shift shaft and disengage the park pawl lever from it.
4. Remove the manual detent lever and the manual valve link from the transaxle.
Installation Procedure

1. Install the manual valve link to the manual detent lever.
Notice
If manual shift shaft is rotated excessively, internal damage to the transaxle range switch may occur.
2. Prevent the manual shift shaft from rotating by holding control lever.
Notice
Refer to Fastener Notice in Cautions and Notices.
3. Install the attachment nut and torque.
Tighten
Tighten the manual detent lever-to-manual detent shaft nut to 12 Nm (9 lb ft).
4. Remove the rag from the transaxle case.

5. Install the valvebody. Refer to Control Valve Body Assembly Removal .
<- Back Forward ->
Document ID# 881408
1998 Saturn SL2/SC2/SW2
Print

You might also like