The document discusses the DiCoder Motor Feedback System produced by Stegmann. It provides contact information for Stegmann, including phone numbers, fax, email, and addresses. It also provides instructions that the removal of fittings from the device should only be done by pressing on the rear of the encoder shaft and not the encoder housing, and to refer to the mounting instructions.
The document discusses the DiCoder Motor Feedback System produced by Stegmann. It provides contact information for Stegmann, including phone numbers, fax, email, and addresses. It also provides instructions that the removal of fittings from the device should only be done by pressing on the rear of the encoder shaft and not the encoder housing, and to refer to the mounting instructions.
The document discusses the DiCoder Motor Feedback System produced by Stegmann. It provides contact information for Stegmann, including phone numbers, fax, email, and addresses. It also provides instructions that the removal of fittings from the device should only be done by pressing on the rear of the encoder shaft and not the encoder housing, and to refer to the mounting instructions.
The document discusses the DiCoder Motor Feedback System produced by Stegmann. It provides contact information for Stegmann, including phone numbers, fax, email, and addresses. It also provides instructions that the removal of fittings from the device should only be done by pressing on the rear of the encoder shaft and not the encoder housing, and to refer to the mounting instructions.
The removal of a fitting of the device should only be effected using the rear end of the encoder shaft. Under no circumstances should you press against the encoder housing! Refer to the Mounting Instructions!