Scribd
Upload
47 views1 page

Check List For Receiving Inspection of Manual Valves: Date-04/06/2014 QCIC/027 Rev-0

This checklist is for receiving inspection of manual valves and contains 6 items to inspect including: 1) Ensuring material requirements are met, 2) Checking that valves are properly marked, 3) Verifying flange dimensions comply with standards, 4) Inspecting butt welding ends are prepared according to ASME standards, 5) Determining if vendor's standard finish is acceptable for coated valves, and 6) A remarks section to note any issues. The document provides acceptance criteria for manual valve inspection upon receipt.

Uploaded by

Tina Miller
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
47 views1 page

Check List For Receiving Inspection of Manual Valves: Date-04/06/2014 QCIC/027 Rev-0

This checklist is for receiving inspection of manual valves and contains 6 items to inspect including: 1) Ensuring material requirements are met, 2) Checking that valves are properly marked, 3) Verifying flange dimensions comply with standards, 4) Inspecting butt welding ends are prepared according to ASME standards, 5) Determining if vendor's standard finish is acceptable for coated valves, and 6) A remarks section to note any issues. The document provides acceptance criteria for manual valve inspection upon receipt.

Uploaded by

Tina Miller
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Item No.

Acceptable
Un
acceptable
Not
Applicable
Not Inspected
1
2
3
4
5
Remarks
Date- 04/06/2014
CHECK LIST FOR RECEIVING INSPECTION OF
MANUAL VALVES
QCIC/027
Rev-0
Acceptance Criteria
Minimum material requirements are met as specified
in the Materials standard.
The valves shall be marked in accordance with the
Project Specification / Manufacturer's Standard
Flange dimensions for steel valves shall comply with
the latest standards
Welding requirements:
a) Butt welding ends for all valve sizes shall be
prepared in accordance with ASME B16.25 for use
without a backing ring.
Vendor's standard finish or paint is acceptable for
Coated Valves

You might also like