Lab Exam: 1-Multimeters 2 - Function Generator 3 - Oscilloscope
The document describes how to use three lab equipment: a multimeter to measure resistance, voltage, current and capacitance; a function generator to output different waveforms by setting the shape, frequency, amplitude and duty cycle; and an oscilloscope to view waveforms by connecting probes and adjusting settings like voltage/division, time/division, and saving screenshots.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0 ratings0% found this document useful (0 votes)
148 views1 page
Lab Exam: 1-Multimeters 2 - Function Generator 3 - Oscilloscope
The document describes how to use three lab equipment: a multimeter to measure resistance, voltage, current and capacitance; a function generator to output different waveforms by setting the shape, frequency, amplitude and duty cycle; and an oscilloscope to view waveforms by connecting probes and adjusting settings like voltage/division, time/division, and saving screenshots.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1
Lab Exam
1- Multimeters 2- Function Generator 3- Oscilloscope
Resistance measurement, Diode Testing and continuity testing. Turn on the device. Turn on the device. AC, DC voltage. Set wave Shape (sinewave, triangular, square). Build a Circuit. Current Measurement (Multimeter, Clamp). Set frequency. Connect Probes to view required waveforms. Measurement of capacitance. Set Amplitude. Adjust setting to view waves properly. Set Duty cycle. Adjust Datum to center of screen. Connect Probes to circuit. Write down current volt/div, time/div Change volt/div, current/div as required. Using Oscilloscope to view following measurements (RMS, Peak-to peak, frequency, Duty Cycle). Using a flash memory save a screenshot of the display. View ripples on screen