Scribd
Upload
25 views

You Should Know This Before You Start: User's Guide

This document outlines the 5 steps to use the mikroBootloader application: 1. Establish a USB link between the board and PC by connecting the board and waiting for the USB icon to turn red. 2. Click connect within 5 seconds to put the chip in bootloader mode. 3. Load the HEX file containing the program onto the mikroBootloader window. 4. Click begin uploading to start the bootloader. 5. The bootloader will reset the MCU and the new program will start in 5 seconds.

Uploaded by

Michael Henderson
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
25 views

You Should Know This Before You Start: User's Guide

This document outlines the 5 steps to use the mikroBootloader application: 1. Establish a USB link between the board and PC by connecting the board and waiting for the USB icon to turn red. 2. Click connect within 5 seconds to put the chip in bootloader mode. 3. Load the HEX file containing the program onto the mikroBootloader window. 4. Click begin uploading to start the bootloader. 5. The bootloader will reset the MCU and the new program will start in 5 seconds.

Uploaded by

Michael Henderson
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

mikroBootloader manual

3. Choose HEX fle


mikroBootloader manual
4. Start Bootloader
mikroBootloader manual
1. Establish USB link
mikroBootloader manual
2. Connect with MCU
mikroBootloader manual
5. Reset chip
Connect your
board to your PC.
When device is
recognized by your
OS the gray USB
icon will turn red,
indicating that USB
link is succesfully
established. You
have 5s to procede
to the next step.
If you wait too long
the device will
disconnect.
Click on the
Connect button
within 5s. The chip
automatically enters
the Bootloader
mode and is
ready for further
instructions.
If your USB link
disconnects, just
reset the chip to
reestablish the link.
Then procede with
step 2 again.
Load the program
you want to upload
into the chip by
clicking on the
Browse for HEX
button or simply
drag and drop
your HEX on to
mikroBootloader
window. Youll
be notifed in the
History Window
that the fle is
opened.
Start bootloader by clicking on the Begin uploading button.
Click on the Show Activity button to view the operation of the
bootloader.
Bootloader frmware
will automatically
reset the MCU,
after which you
should wait 5s for
your newly loaded
program
to start.
This is a short manual that describes the operation of
mikroBootloader application. You will fnd that fve simple steps
are all it takes to successfully load your new program into the MCU.
You should know this before you start
mikroBootloader
Users
Guide
1
USB HID Bootloader v1.0.0.0 application may only be
used with the appropriate device USB HID Bootloader
frmware version 1.0.0.0, which is free of charge and
can be downloaded from mikroElektronikas website.
2
Bootloader uses USB HID class connection, and no
additional OS drivers are required for proper operation.
USB HID bootloader for all MCU families
for more information visit http://www.mikroe.com

You might also like