Scribd
Upload
14 views2 pages

1931 Ex4

1. This document outlines Laboratory 4 for the Basic Electronic Instrumentation course. The lab focuses on using an analog digital trainer, DC power supply, and oscilloscope to observe digital signals and logic gates. 2. Students will connect circuits with LEDs, resistors, and function generators. They will record observations on LED behavior as resistor values and input frequencies are adjusted. 3. The lab also involves using an analog digital trainer to implement AND and OR logic gates. Students observe and record the output for different input configurations of the gates.

Uploaded by

semuty92
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
14 views2 pages

1931 Ex4

1. This document outlines Laboratory 4 for the Basic Electronic Instrumentation course. The lab focuses on using an analog digital trainer, DC power supply, and oscilloscope to observe digital signals and logic gates. 2. Students will connect circuits with LEDs, resistors, and function generators. They will record observations on LED behavior as resistor values and input frequencies are adjusted. 3. The lab also involves using an analog digital trainer to implement AND and OR logic gates. Students observe and record the output for different input configurations of the gates.

Uploaded by

semuty92
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

BEE/1011I

Faculty of Electrical & Electronics Engineering


BEE1931Basic Electronic Instrumentation
LABORATORY 4
Std. ID: ____________________
Mapping CO,PO,Domain,KI: CO2,PO2,P4,CTPS3
CO2: Utilize DC power supply, oscilloscope, function generator, digital multi-meter and Analog Digital Trainer.
PO2: Psychomotor/Practical/Technical Skills
P4: Mechanism
CTPS3: Find idea and alternative solutions.
Learning Outcomes:
At the end of this experiment, students should be able to:
a) Apply right safety precaution in laboratory and workplace.
b) Able to use analog digital trainer.
c) Able to validate digital signal using oscilloscope.
Instruction
Part I
1.
2.
Part II
1.
2.
Part III
1.
2.

Connect the circuit as shown in Figure 1.


Adjust the value of R1 and record your observation on LED1.
Connect the circuit as shown in Figure 2.
Adjust the frequency of the supply and record your observation on LED1.
Place and connect AND and OR gate using the Analog Digital Trainer.
Record your observation based on configuration in Table 1 and Table 2.

Result / Data / Calculation


R1

R1

R2

R2

LED1

LED1
DC

10V Vpp

5V Dc

Figure 1

Figure 2

BEE/1011I

1. Observation on Figure 1
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
2. Observation on Figure 2
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
3. Observation on Logic Gates.
AND Gate

OR Gate

A
B

Discussion/ conclusion

A
B

You might also like