Scribd
Upload
357 views3 pages

Tasks 1&2 Config Bios

This document provides instructions for configuring BIOS settings and managing system passwords. It describes how to enter the BIOS setup by pressing Del or F2 at startup, then navigate to options to set the date and time, hard drive parameters, and boot sequence. It also explains how to set, change, or disable supervisor and user passwords in the BIOS, including entering the password menu and saving changes.

Uploaded by

philip derit
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
357 views3 pages

Tasks 1&2 Config Bios

This document provides instructions for configuring BIOS settings and managing system passwords. It describes how to enter the BIOS setup by pressing Del or F2 at startup, then navigate to options to set the date and time, hard drive parameters, and boot sequence. It also explains how to set, change, or disable supervisor and user passwords in the BIOS, including entering the password menu and saving changes.

Uploaded by

philip derit
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

BIOS/CMOS SETUP

Task 1: Configure BIOS Setup

Steps:
1. Turn on the computer.
2. Press Del or F2 key to enter BIOS Setup.
3. At BIOS Setup window, select Standard CMOS Features.
4. At Standard CMOS Features, you can configure Date, Time, Hard disk, CD-ROM Drive and
Floppy Disk Drive Parameters.

Primary IDE Master:


Primary IDE Slave:
Secondary IDE Master:
Secondary IDE Slave:

Drive A: 1.44MB, 3.5 inch


Drive B: None
Video: EGA/VGA
Halt On: All Errors

5. Press Esc to quit Standard CMOS Setup


6. Select Advanced BIOS Features for Boot Sequence configuration

First Boot Device : CDROM


Second Boot Device : Hard Disk
Third Boot Device : Floppy

Note: To change the boot sequence, select the device (ex: CDROM), press enter and select the
desired device for the intended boot sequence.

7. After applying any changes to CMOS setup, press F10 to save changes to CMOS and EXIT
SETUP

Save to CMOS and EXIT (Y/N)? Y (press enter)

Note:
Esc: Quit : Select Item PgUp/PgDn/+/-: Modify
F1: Help Shift F2: Change Color
Task 2: Set / Change / Disable System Password

To set password:

1.Turn on the computer.


2.Press Del or F2 key to enter BIOS Setup
3.Select user Supervisor or User Password menu.
4.To set password.

Enter Password : ex: TESDA (press enter)


Confirm Password : TESDA (press enter)

5.Press F10 to Save and Exit Setup.

To change password:

1.Turn on the computer and press Del or F2 key to enter BIOS Setup.
2.Enter Password: ex: TESDA
3.Select Supervisor or User Password menu

Enter Password : ex: RTC (press enter)


Confirm Password : RTC (press enter)

4.Press F10 to Save and Exit Setup.

To disable password

3 Ways:
1. Disable password at BIOS Setup.

 Turn on the computer and press Del or F2 key to enter BIOS Setup
 Enter Password: ex: RTC (press enter)
 Select Supervisor or User Password menu

Enter Password: (Do not type any password, just press Enter)
PASSWORD DISABLED!!!
Press any key to continue

 Press F10 to Save and Exit Setup.

2. Set CMOS jumper to clear the CMOS Settings.


3. Remove and reinsert CMOS battery.

You might also like