Multiplexing TechniquesChapter 7 PDF

EE4512 Analog and Digital Communications Chapter 7
Chapter 7
Chapter 7
Multiplexing Techniques
Chapter 7
Chapter 7
Time Division Multiplexing

Time Division Multiplexing
Pages 364
Pages 364
-
-
368
368
Time division multiplexing

Time division multiplexing
(TDM) combines several low,
(TDM) combines several low,
fixed and predefined bit rate sources into a single high
fixed and predefined bit rate sources into a single high
speed bit stream for transmission over a single digital
speed bit stream for transmission over a single digital
communication channel:
communication channel:
Demultiplexer Demultiplexer Multiplexer Multiplexer
Time slots Time slots
The
The
TDM time slots have to be chosen properly. If the time
TDM time slots have to be chosen properly. If the time
slots are too small (for example, 1 bit) then the multiplexer
slots are too small (for example, 1 bit) then the multiplexer
and demultiplexer must switch rapidly. If the time slots are
and demultiplexer must switch rapidly. If the time slots are
too large (for example, 64 Kb) then the data must be
too large (for example, 64 Kb) then the data must be
buffered
buffered
and
and
delay
delay
would be produced. TDM is used for
would be produced. TDM is used for
baseband (
baseband (
not
not
bandpass) data transmission.
bandpass) data transmission.
Demultiplexer Demultiplexer Multiplexer Multiplexer
Time slots Time slots
The T1 TDM system for telephone networks uses a 193 bit

The T1 TDM system for telephone networks uses a 193 bit
frame
frame
where each frame has 24 8
where each frame has 24 8
-
-
bit
bit
slots
slots
and 1
and 1
-
-
bit in each
bit in each
frame for signaling. The T1 bit rate r
frame for signaling. The T1 bit rate r
b b
= 1.544 Mb/sec.
= 1.544 Mb/sec.
The duration of each frame T
The duration of each frame T
f f
= 193 b / 1.544 Mb/sec =
= 193 b / 1.544 Mb/sec =
125
125
sec or 8 k samples/sec. Here all the data sources

sec or 8 k samples/sec. Here all the data sources
have the same data rate.
have the same data rate.
S&M Figure 7
S&M Figure 7
-
-
3
3
If the data sources have different rates a

If the data sources have different rates a
multiplexer
multiplexer
scheme
scheme
must reconcile the disparate rates.
must reconcile the disparate rates.
The data rates are in the lowest possible ratio of 8:16:24 or
The data rates are in the lowest possible ratio of 8:16:24 or
1:2:3 for a total of 1 + 2 + 3 = 6 slots. The slots are
1:2:3 for a total of 1 + 2 + 3 = 6 slots. The slots are
apportioned to the channels as:
apportioned to the channels as:
a b b c c c
a b b c c c
and the channel
and the channel
data rate is 48 kb/sec.
data rate is 48 kb/sec.
Another example is data rates of 10, 15, 20, and 30 Kb/sec
Another example is data rates of 10, 15, 20, and 30 Kb/sec
which reduces to 2:3:4:6 (the LCD is 5) for 2 + 3 + 4 + 6 =
which reduces to 2:3:4:6 (the LCD is 5) for 2 + 3 + 4 + 6 =
15 slots
15 slots
and the channel data rate is
and the channel data rate is
45 kb/sec.
45 kb/sec.
S&M Figure 7
S&M Figure 7
-
-
4
4
If data arrives
If data arrives
asynchronously
asynchronously
from variable rate sources, a
from variable rate sources, a
statistical multiplexer
statistical multiplexer
with input buffers is used. The design
with input buffers is used. The design
is performed by observation and tested in simulation.
is performed by observation and tested in simulation.
S&M Figure 7
S&M Figure 7
-
-
5
5
The statistical TDM packet consists of a

The statistical TDM packet consists of a
start flag
start flag
,
,
address
address
field
field
,
,
control field
control field
,
,
information bits
information bits
,
,
error control,
error control,
and an
and an
end
end
flag.
flag.
S&M Figure 7
S&M Figure 7
-
-
6
6
TCP/IP data packet
TCP/IP data packet
TDM with four equal data rate sources r

TDM with four equal data rate sources r
b b
= 250 b/sec and a
= 250 b/sec and a
transmission rate
transmission rate
r
r
TDM TDM
= 1 kb/sec
= 1 kb/sec
0110
TDM with unequal data rate sources r

TDM with unequal data rate sources r
b b
= 250, 250 and 500
= 250, 250 and 500
b/sec and a transmission rate
b/sec and a transmission rate
r
r
TDM TDM
= 1 kb/sec
= 1 kb/sec
r r
b b
= 500 b/sec (input) = 500 b/sec (input)
r
TDM
= 1 kb/sec
r r
b b
= 500 b/sec (output) = 500 b/sec (output)
1 msec delay 1 msec delay
Chapter 7
Chapter 7
Frequency Division Multiplexing

Frequency Division Multiplexing
Pages 368
Pages 368
-
-
370
370
Frequency division multiplexing

Frequency division multiplexing
(FDM) divides the total
(FDM) divides the total
bandwidth available to the system into
bandwidth available to the system into
non
non
-
-
overlapping
overlapping
frequency sub
frequency sub
-
-
bands for transmission over a single digital
bands for transmission over a single digital
communication channel.
communication channel.
FDM usually utilizes

FDM usually utilizes
guard bands
guard bands
to separate the digital
to separate the digital
data transmissions. FDM is used for bandpass (
data transmissions. FDM is used for bandpass (
not
not
baseband) data transmission
baseband) data transmission
FDM for
FDM for
FM broadcasting
FM broadcasting
over a cable system:
over a cable system:
S&M
Figure 7-7a
WXTU
WXTU
WQAN
Scranton
WPTS
Pittsburgh
FDM employs a common shared bandwidth but here with

FDM employs a common shared bandwidth but here with
no apparent guard bands.
no apparent guard bands.
S&M Figure 7
S&M Figure 7
-
-
7b
7b
Optical FDM is usually called

Optical FDM is usually called
wavelength division
wavelength division
multiplexing
multiplexing
(WDM) and utilizes separate wavelengths
(WDM) and utilizes separate wavelengths
(
(
)
)
of light.
of light.
TDM is used for baseband and FDM for bandpass data

TDM is used for baseband and FDM for bandpass data
transmission. FDM requires the assignment and
transmission. FDM requires the assignment and
coordination of carrier frequencies which can be
coordination of carrier frequencies which can be
problematic.
problematic.
Code division multiple access
Code division multiple access
(CDMA) utilizes
(CDMA) utilizes
spread spectrum modulation over the same frequency
spread spectrum modulation over the same frequency
band. CDMA is considered in EE4542 Telecommunications
band. CDMA is considered in EE4542 Telecommunications
Engineering.
Engineering.
FDM PSD with three equal data rate sources r

FDM PSD with three equal data rate sources r
b b
= 1 kb/sec
= 1 kb/sec
and three carrier frequencies of 15.5, 20 and 24.5 kHz.
and three carrier frequencies of 15.5, 20 and 24.5 kHz.
BASK (OOK) BASK (OOK)
BFSK (MFSK) BFSK (MFSK)
BPSK BPSK
End of Chapter 7
End of Chapter 7

Multiplexing TechniquesChapter 7 PDF

Uploaded by

Copyright:

Available Formats

Multiplexing TechniquesChapter 7 PDF

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Multiplexing TechniquesChapter 7 PDF

Uploaded by

Copyright:

Available Formats

EE4512 Analog and Digital Communications Chapter 7

Time Division Multiplexing

Time division multiplexing

The T1 TDM system for telephone networks uses a 193 bit

sec or 8 k samples/sec. Here all the data sources

If the data sources have different rates a

The statistical TDM packet consists of a

TDM with four equal data rate sources r

TDM with unequal data rate sources r

Frequency Division Multiplexing

Frequency division multiplexing

FDM usually utilizes

FDM employs a common shared bandwidth but here with

Optical FDM is usually called

TDM is used for baseband and FDM for bandpass data

FDM PSD with three equal data rate sources r

You might also like