Scribd
Upload
242 views1 page

Flowchart For s1 Counter

The document describes the process of setting up a signaling connection between a UE and RBS triggered by an initial UE message. It involves the following steps: (1) the UE sends an initial message to the RBS, (2) the RBS responds with connection establishment attempts based on the cause, (3) if no timeout occurs, the MME sends an initial context setup request to the RBS, (4) the RBS confirms connection establishment on receiving a message on the newly established connection. Performance measurements are captured at various steps.

Uploaded by

josine.conti5913
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
242 views1 page

Flowchart For s1 Counter

The document describes the process of setting up a signaling connection between a UE and RBS triggered by an initial UE message. It involves the following steps: (1) the UE sends an initial message to the RBS, (2) the RBS responds with connection establishment attempts based on the cause, (3) if no timeout occurs, the MME sends an initial context setup request to the RBS, (4) the RBS confirms connection establishment on receiving a message on the newly established connection. Performance measurements are captured at various steps.

Uploaded by

josine.conti5913
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Signalling connection setup triggered by initial UE message

UE

Initial UE message

RBS

pmS1SigConnEstabAtt + pmS1SigConnEstabAttEm + step for cause Emergency pmS1SigConnEstabAttHpa + step for cause High Prio Access pmS1SigConnEstabAttMod + step for cause Mobile Originating Data pmS1SigConnEstabAttMta + step for cause Mobile Terminating Access pmS1SigConnEstabAttMos + step for cause Mobile Originating Signalling

pmS1SigConnEstabAttEm + pmS1SigConnEstabAttHpa + pmS1SigConnEstabAttMod + pmS1SigConnEstabAttMta + pmS1SigConnEstabAttMos +

Yes

RBS timeout on initial context setup request from MME? No

MME sends initial context setup request to RBS

RBS

Initial context MME setup request (E-RABs, Sec keys)

Any message received on the S1 logical connection ? Yes pmS1SigConnEstabSucc +

No

Stepped for any of the following messages: S1 downlink NAS transport S1 UE context release command S1 initial context setup request S1 reset

pmS1SigConnEstabSuccEm + pmS1SigConnEstabSuccHpa + pmS1SigConnEstabSuccMod + pmS1SigConnEstabSuccMta + pmS1SigConnEstabSuccMos +

pmS1SigConnEstabSuccEm + step for cause Emergency pmS1SigConnEstabSuccHpa + step for cause High Prio Access pmS1SigConnEstabSuccMod + step for cause Mobile Originating Data pmS1SigConnEstabSuccMta + step for cause Mobile Terminating Access pmS1SigConnEstabSuccMos + step for cause Mobile Originating Signalling Note: Corresponding counter per QCI: pmErabEstabAttInitQci Stepped for each E-RAB that has the given ARP Priority Level

pmUeCtxtEstabAtt + pmErabEstabAttInit +

pmErabEstabAttInitArp +

A
L0000312G

You might also like