Scribd
Upload
33 views8 pages

Amplifier With Buffer Configuratoin: KLE Society's B.V. Bhoomaraddi College of Engineering and Technology, Hubli

This document summarizes the design of an amplifier configured as a buffer. The objective is to achieve high open-loop gain and output voltage swing to drive load capacitance. It will explore single-stage and cascoded op-amp architectures with specifications including a gain factor of 1, offset of +/-5mV, setting time of 80ns, and ability to drive a 2pF load. The design is intended to operate from a 1.8V supply with a temperature range of -40 to 125 degrees Celsius.

Uploaded by

Abhishek Mat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
33 views8 pages

Amplifier With Buffer Configuratoin: KLE Society's B.V. Bhoomaraddi College of Engineering and Technology, Hubli

This document summarizes the design of an amplifier configured as a buffer. The objective is to achieve high open-loop gain and output voltage swing to drive load capacitance. It will explore single-stage and cascoded op-amp architectures with specifications including a gain factor of 1, offset of +/-5mV, setting time of 80ns, and ability to drive a 2pF load. The design is intended to operate from a 1.8V supply with a temperature range of -40 to 125 degrees Celsius.

Uploaded by

Abhishek Mat
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 8

KLE Societys B.V.

Bhoomaraddi College of Engineering and Technology, Hubli

AMPLIFIER WITH BUFFER CONFIGURATOIN


Under the guidance of Prof. R B Shettar
Mentor : Mr. Charan & Mr. Sourab By, Mr. Abhishek C Math

Overview
Introduction Objective Literature survey Methodology Results Conculsion

INTRODUCTION
A buffer amplifier is one that provides electrical impedance transformation from one circuit to another. Two main types of buffer exist: 1. voltage buffer 2. current buffer Voltage buffer having a high output impedance level to a low input impedance level. Current buffer having a low output impedance level to a high input impedance level.

OBJECTIVE

To design the amplifier as a buffer to achieve the high open loop gain and the high output voltage swing and to drive the load capacitance

LITERATURE SURVEY
Different types of architecture 1.Single stage op amp

2. Cascoded op amp

Specification

Vdd : 1.8V +/- 10% ; Temp : -40 C to 125 C Vin CM : 1.2V

Buffer Configuration : Gain factor of 1


Accuracy(Offset) : +/-5mV, Setting Time : 80ns Load Cap : 2pF

DC Gain : 50dB, UGB : 10MHz

Single stage buffer with the current mirror load

You might also like