Scribd
Upload
45 views5 pages

Objectives: Cutting Cable Using Crimper

This document provides procedures for preparing and testing network cables and configuring a basic network. It involves: 1) Preparing straight and crossover Ethernet cables using a crimper and cutting cables to different lengths. 2) Connecting the cables to RJ45 sockets and testing them using a cable tester. 3) Connecting computers to a switch using the prepared cables and configuring the TCP/IP settings. 4) Testing the network connection by opening an internet browser.

Uploaded by

Wani Syazwani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
45 views5 pages

Objectives: Cutting Cable Using Crimper

This document provides procedures for preparing and testing network cables and configuring a basic network. It involves: 1) Preparing straight and crossover Ethernet cables using a crimper and cutting cables to different lengths. 2) Connecting the cables to RJ45 sockets and testing them using a cable tester. 3) Connecting computers to a switch using the prepared cables and configuring the TCP/IP settings. 4) Testing the network connection by opening an internet browser.

Uploaded by

Wani Syazwani
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 5

LAB 1 : Cables preparation and interconnecting LAN OBJECTIVES a.

Preparing two types of networks cables which is straight and crossover. b. Interconnecting network e !ip"ents. EQUIPMENTS a. Cri"per b. Cable tester c. #$P cable d. %&'( socket PROCEDURES a. )irst of all* we have to prepare for two cables that are straight and crossover cables. b. By !sing cri"per* c!t the cable to divide the cable into two as shown in pict!re below. )or crossover cable "ake it a bit shorter than the straight cable so that can be recogni+e easily.

Cutting cable using crimper

c. Based on the cable arrange"ents fig!re below* arrange the two cables. %e"e"ber to do it on the both sides of the cables.

Straight cable

Crossover cable

d. After the arrange"ents are done* p!t it in the %&'( socket. )ig!re below is the pict!re of %&'( socket.

RJ45

e. $o "ake s!re that the arrange"ents are correct we will test the" !sing cables tester. By connecting the cable to tester* observe if the light is on or not. If the light is on "eans that the cable can be !se.

Testing the cable

LAB , : Network Config!ration and $esting

OBJECTIVES a. Config!ring networks. b. $esting network connections.

EQUIPMENTS a. Co"p!ters b. -witch./!b

PROCEDURES

1. By !sing cables that yo! had prepared before in Lab 1* connect all the co"p!ters to the switch or h!b. 0o! can !se any port between I1,' b!t do not connect the co"p!ter to the !plink port. -ee fig!re c. ,. -tart with fig!re c2i3 and then fig!re c2ii3.

c(i)

c(ii)

4. $hen* config!re network by open control panel 5 Network connections. '. -elect yo!r connection* click Properties.
5. -elect $CP.IP Protocol and click Properties.

6. )ro" here* yo! can edit yo!r config!ration setting "an!ally. 7. $esting the connection by opening any internet browser.

You might also like