Scribd
Upload
21 views1 page

Flash Flood

The system continuously monitors water levels using a circuit. If the level exceeds a limit, the microcontroller displays the data and transmits it via SMS to the control room using a GS modem. Location details are also transmitted. The GS modem connects to the microcontroller via transceivers and requires a SIM card to communicate outside data like monitored water levels, which are converted from analog to digital by an ADC and sent to the microcontroller.

Uploaded by

Sandhya Devi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
21 views1 page

Flash Flood

The system continuously monitors water levels using a circuit. If the level exceeds a limit, the microcontroller displays the data and transmits it via SMS to the control room using a GS modem. Location details are also transmitted. The GS modem connects to the microcontroller via transceivers and requires a SIM card to communicate outside data like monitored water levels, which are converted from analog to digital by an ADC and sent to the microcontroller.

Uploaded by

Sandhya Devi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

WORKING PROCEDURE

The working of the project goes like this: The system monitors the water level through the circuit continuously. If the water level is detected above a limit the microcontroller displays the data. The water level is transmiited to the control room through sms. For messaging GS modem is used. The location details are also transmitted. The GS are connected to the microcontroller using TT! to "S#$# transceivers. The GS modem is e%actly similar to our mobile phones. &ven the modem re'uires a SI card to communicate with the outside world. The data which are monitored continuously in this project is the water level. The analog 'uantities are taken and converted into corresponding digital values using an ()*. This converted digital value is sent to the microcontroller. The microcontroller temporarily stores this value. The mobile numbers are predefined and stored in the microcontroller. (n !*) display is used to display the messages. )isplay is connected to the microcontroller using display driver. *ontrol room transmits the stop message through sms to the train.

You might also like