Scribd Logo
Upload

Welcome to Scribd!

  • 18 views

    1 Structure Camber

    Uploaded by

    bollid
    The document outlines camber and sweep tolerances for steel sections produced by Nucor-Yamato Steel. Camber tolerance increases with section length up to a maximum of 3 inches for sections over 66 feet long, denoting acceptable curvature of the long flange from being perfectly flat. Sweep tolerance is defined as curvature of the web and must not exceed 0.125 inches multiplied by the total section length.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    1 Structure Camber

    Uploaded by

    bollid
    18 views1 page
    The document outlines camber and sweep tolerances for steel sections produced by Nucor-Yamato Steel. Camber tolerance increases with section length up to a maximum of 3 inches for sections over 66 feet long, denoting acceptable curvature of the long flange from being perfectly flat. Sweep tolerance is defined as curvature of the web and must not exceed 0.125 inches multiplied by the total section length.

    Original Description:

    catalog

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    The document outlines camber and sweep tolerances for steel sections produced by Nucor-Yamato Steel. Camber tolerance increases with section length up to a maximum of 3 inches for sections over 66 feet long, denoting acceptable curvature of the long flange from being perfectly flat. Sweep tolerance is defined as curvature of the web and must not exceed 0.125 inches multiplied by the total section length.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    18 views1 page

    1 Structure Camber

    Uploaded by

    bollid
    The document outlines camber and sweep tolerances for steel sections produced by Nucor-Yamato Steel. Camber tolerance increases with section length up to a maximum of 3 inches for sections over 66 feet long, denoting acceptable curvature of the long flange from being perfectly flat. Sweep tolerance is defined as curvature of the web and must not exceed 0.125 inches multiplied by the total section length.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Nucor-Yamato Steel

    Camber Tolerance: Camber denotes the curvature from the plane of either flange in the length of the section. If section is cambered, the camber of the long flange must be high at the center of length, and within limits specified below. Lengths Up to 41 foot inclusive Over 41 foot to 51 foot inclusive Over 51 foot to 66 foot inclusive Over 66 foot to 82 foot inclusive Maximum, inches * 1.25 1.50 2.00 3.00

    * Positive camber in overall straightness refers to when the outer face of the long flange is convex over the length of the center sill zee. Sweep Tolerance: Sweep denotes the curvature from the plane of the web in the length of the section. Maximum sweep in either direction = 0.125 inches X number of feet of total length 5

    August 2013

    You might also like