Scribd
Upload
140 views

Airbag Control Module

The document provides instructions for removing, installing, and inspecting an airbag control module. The removal process involves turning off the ignition, disconnecting the battery for at least 20 seconds, removing console covers, disconnecting the control module connector, and removing four bolts. Installation is the reverse of removal and requires new hexagon bolts. Inspection checks for damage to the control module, connector, mounting bracket, and deployment of airbags.

Uploaded by

akcess
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
140 views

Airbag Control Module

The document provides instructions for removing, installing, and inspecting an airbag control module. The removal process involves turning off the ignition, disconnecting the battery for at least 20 seconds, removing console covers, disconnecting the control module connector, and removing four bolts. Installation is the reverse of removal and requires new hexagon bolts. Inspection checks for damage to the control module, connector, mounting bracket, and deployment of airbags.

Uploaded by

akcess
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AIRBAG CONTROL MODULE

AIRBAG SYSTEM

7. Airbag Control Module


A: REMOVAL
CAUTION: Do not disassemble the airbag control module. If the airbag control module is deformed or if water damage is suspected, replace the airbag control module with a new genuine part. Do not drop the airbag control module. After removal, keep the airbag control module on a dry, clean surface away from moisture, heat, and dust. 1) Turn the ignition switch to OFF. 2) Disconnect the ground cable from battery, and wait for at least 20 seconds before starting work. 3) Remove the console cover. <Ref. to EI-36, REMOVAL, Console Box.> 4) Remove the center console panel. <Ref. to EI37, REMOVAL, Instrument Panel Assembly.> 5) Disconnect the connector from airbag control module. 6) Remove the four bolts.

AB-00035

B: INSTALLATION
CAUTION: Use new hexagon head bolts (for airbag control module only) during reassembly. Install in the reverse order of removal. Tightening torque: Refer to COMPONENT in General Description <Ref. to AB-2, SRS AIRBAG, COMPONENT, General Description.>

C: INSPECTION
Check for the following, and replace damaged parts with new parts. Control module, connector, and mounting bracket are damaged. Airbag is deployed. Side airbag is deployed.

AB-16

You might also like