Proofread
Proofread
Proofread
Proofreading is the final step of the writing process completed only after the larger concerns of focus, development, organization, and coherence have been satisfied. We proofread to find grammar, spelling, and punctuation errors, omitted or extra words, and typos. However, proofreading is not the same as reading! Most writers cant simply read over their writing and find all their sentence errors. But if writers use an effective system for proofreading their papers, they are sure to spot more errors than had they only read over their papers. Proofreading takes time. You should allow an adequate amount of time for this step. Start keeping a Proofreading Log. Its unrealistic for most students to think theyll be able to find all possible errors when they proofread. Therefore, its more time efficient to know the kinds of errors you typically make and to be sure to check for those errors first. One way to gain this knowledge is to keep a log of all the grammar, punctuation, and sentence structure errors you make to discover which ones are repeated. When your teachers make corrections on your papers, record those errors on a log sheet. Whats the solution for that kind of error, and what should you look for in your writing to spot that kind of error in the future? Read your writing out loud. When you read out loud, you slow your normal reading speed. This can help you find errors that you might miss when reading silently. (Note: Non-native English speakers may have more difficulty hearing problems in writing if they are inexperienced writers and readers. Still, reading out loud is a valuable activity to practice and learn from.) Listen to someone else read your writing out loud. Pay close attention while listening to another person read your writing. Note the places that give the reader difficulty. For example, s/he might stop in the middle of a sentence or falter over a word. That could be where a word is missing or misplaced. If the reader isnt reading fluently, that could signal problems with the text: sentence structure problems, grammar and punctuation problems, word choice issues, etc. (Occasionally, you might find a content problem while proofreading, but if your writing has gone through revisions before this step, any problems with content should have already been addressed.) The Readers Role. Whoever reads aloud should mark the places (words, sentences, sections) that give them difficulty or cause questions. The writer can then focus on those areas to see what the problem is, correct the problem, or question it. When reading out loud would be disruptive, try an alternative strategy. Sometimes its not possible to read out loud, depending upon your circumstances. In that case, try anything that slows your normal pace of reading. For example, try sub-vocalization, where you pronounce each word under your breath. Another quiet strategy is to use a finger or pencil to point to each word and punctuation mark. Let some time go by between writing your paper and proofreading it. The more time you leave before proofreading your paper, the less youll remember specific wording, which will help you focus more on the text.
Comma Splices To find comma splices, start at the beginning of your paper and skim, stopping at each comma. Then read the part of the sentence that precedes the comma. Does that part of the sentence make sense by itself? If so, then read the part that follows the comma. Do those words make sense by themselves, too? If so, the sentence is probably a comma splice error, which is a particular kind of run-on sentence. You can correct a comma splice in three different ways. First, you could add a coordinating conjunction directly after the comma to connect the two ideas. Second, you could replace the comma with a period. Third, you could replace the comma with a semi-colon if the two clauses are closely related to each other. Run-ons Run-ons are more difficult to detect than fragments and comma splices. They are sentences run together expressing two or more complete thoughts without correct punctuation or a correct connecting word. One good way to detect a run-on sentence is to listen to your voice as you read the sentence out loud at a normal pace. When your voice drops in tone and hesitates before reading more, thats a clue that you may have reached the end of a complete thought. Some run-ons can be corrected with a period or semicolon separating the complete thoughts. Other run-ons are better corrected by adding a comma and coordinating conjunction. Spelling and Typos Of course, the Spell Check feature on computers can find many spelling errors, but you cant rely on it for all spelling. The most useful strategy to detect spelling and typo errors is to read your paper backwards from the end to the beginning, word by word. However, this is very time-consuming on a long paper, and it doesnt catch homophone errors (to, too, two) or errors such as quit/quite/quiet. (Your computers Spell Check feature wont catch those errors either.) The most helpful strategy for catching spelling errors is to know your own error patternthe words that always give you trouble. Keep your own alphabetized log of words you misspell and use that as a reference for proofreading.