Scribd
Upload
30 views1 page

Assignment 2: Chapter - 2 Pressure Fluid Measurement

This document contains an assignment on plant control systems with questions about pressure fluid measurement. It includes: 1) Drawing a labeled block diagram of a pressure measurement system with a transducer, signal processor, and analog meter. The transducer outputs 0-10mV for a 0-5 bar input and the processor converts it to a 4-20mA signal. 2) Calculating the indicated pressure if the processor outputs 15mA. 3) Explaining the primary and secondary elements of a pressure transducer. 4) Describing how a bellows-type pressure detector produces an output signal, including its detection and signal generation methods. 5) Describing how a bourdon tube

Uploaded by

Laily Edaris
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
30 views1 page

Assignment 2: Chapter - 2 Pressure Fluid Measurement

This document contains an assignment on plant control systems with questions about pressure fluid measurement. It includes: 1) Drawing a labeled block diagram of a pressure measurement system with a transducer, signal processor, and analog meter. The transducer outputs 0-10mV for a 0-5 bar input and the processor converts it to a 4-20mA signal. 2) Calculating the indicated pressure if the processor outputs 15mA. 3) Explaining the primary and secondary elements of a pressure transducer. 4) Describing how a bellows-type pressure detector produces an output signal, including its detection and signal generation methods. 5) Describing how a bourdon tube

Uploaded by

Laily Edaris
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

PLANT CONTROL SYSTEM 1 DEPARTMENT OF MECHANICAL ENGINEERING

ASSIGNMENT 2
SUBJECT CODE&NAME : J4144 PLANT CONTROL SYSTEM 1 SEM : V

CHAPTER 2 PRESSURE FLUID MEASUREMENT


1. An instrument system consists of pressure transducer with a range of 0 to 5 bar and a corresponding output of 0 to 10 mV. The output is connected to an electronic processor which converts the output into a current in the range 4 to 20 mA and an analogue meter which indicates the measured pressure. a. !raw a neat labelled bloc" diagram of the system. b. !educe and write down the e#uation lin"ing the output and input of the pressure transducer. c. The output of the signal processor is 15 mA. !educe the indicated pressure. $20%& 2. A pressure gauge has a range of 0 to '0 bar and is guaranteed to be accurate to within (4) f.s.d. *alculate the possible pressure range when the gauge indicates 50 bar. $10%& +. ,riefly e-plained the primary and the secondary element of a transducers for pressure measurement. $'%& 4. ./01A23 how a bellows4type pressure detector produces an output signal including5 a. %ethod of detection b. %ethod of signal generation $6%& 5. ./01A23 how a bourdon tube4type pressure detector produces an output signal including5 a. %ethod of detection b. %ethod of signal generation $6%&

You might also like