Scribd
Upload
24 views2 pages

Comando S

The document lists configure commands for networking devices including commands for access lists, banners, boot settings, CDP, clock settings, crypto, enabling other commands, exiting modes, hostnames, interfaces, IP settings, logging, MAC addresses, port channels, privilege levels, and terminal line settings.

Uploaded by

Emmanuel Marquez
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
24 views2 pages

Comando S

The document lists configure commands for networking devices including commands for access lists, banners, boot settings, CDP, clock settings, crypto, enabling other commands, exiting modes, hostnames, interfaces, IP settings, logging, MAC addresses, port channels, privilege levels, and terminal line settings.

Uploaded by

Emmanuel Marquez
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Comandos Configure commands: access-list banner boot cdp clock crypto do enable end exit hostname interface ip line

logging mac Add an access list entry Define a login banner Boot Commands Global CDP configuration subcommands Configure time-of-day clock Encryption module To run exec commands in config mode Modify enable password parameters Exit from configure mode Exit from configure mode Set system's network name Select an interface to configure Global IP configuration subcommands Configure a terminal line Modify message logging facilities MAC configuration

mac-address-table Configure the MAC address table mls no mls global commands Negate a command or set its defaults EtherChannel configuration Command privilege parameters

port-channel privilege --More

access-class Filter connections based on an IP access list databits default Set number of data bits per character Set a command to its defaults

exec-timeout Set the EXEC timeout exit Exit from line configuration mode

flowcontrol Set the flow control history Enable and control the command history function

ipv6 logging login

IPv6 options Modify message logging facilities Enable password checking

motd-banner Enable the display of the MOTD banner no parity password privilege speed stopbits transport Negate a command or set its defaults Set terminal parity Set a password Change privilege level for line Set the transmit and receive speeds Set async line stop bits Define transport protocols for line

You might also like