PCI Sound CardSound Maker Value 4.1/5.

1 Sound Card

PCI Sound Card

Genius Sound Maker Value Series

User Manual
TABLE OF CONTENTS
Overview 2 Installing the sound card ..4 Appendix A. Hardware Information 8 FCC and CE Radiation Norm FCC
This equipment has been tested and found to comply with limits for a Class B digital device pursuant to Part 15 of Federal Communication Commission (FCC) rules.

CE
This equipment has been tested and found to comply with the limits of the European Council Directive on the approximation of the law of the member states relating to electromagnetic compatibility (89/336/EEC) according to EN 55022 class B.

FCC and CE Compliance Statement

These limits are designed to provide reasonable protection against frequency interface in residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed or used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connect to

CAUTION!
The Federal Communication Commission warns the user that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

1.Overview
1.1 Sound Maker Value 4.1 Features
Chipset CMI8738 / PCI-SX 4Ch form C-Media Technology System Interface 32bit PCI Bus Master, PCI 2.1 compliant Hardware Interface Newest single chip 4 channel PCI sound audio (Plug and Play (PnP)) solution HRTF-base 3D positional audio, supporting DirectSoundTM3D, A3D interface Support multi-speaker output to 2 / 4 speakers Support EAXTM, Karaoke Echo, key Surround sound High Performance Dual Game Port MPU401 compatible MIDI interface Comply with Microsoft PC99 specification DLS-base Wavetable music synthesizer, supporting Direct Music Fully Sound Blaster, Sound Blaster Pro compatible and Direct Sound compatible Full-duplex playback and recording Connector Front-Out, Rear-Out, Line-In, MIC-In and Game/MIDI port CD Audio, AUX Connector

System Requirements
IBM compatible PC with 32-bit PCI slot. Microsoft Windows 98/98SE/Me/2000/XP/NT4.0/DOS or Linux Intel Pentium 166MHz CPU above (Recommended) 32 MB system memory (Minimum) 100 MB available HDD space CD-ROM drive (or DVD-ROM drive Recommended)

Software Bundle
Multi-channel Speaker Tester Powerful Audio Rack (CD / Midi / Wav / MP3 Player )

Package
Plug and Play PCI sound card User manual Installation Software CD-ROM

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

1.2 Sound Maker Value 5.1 Features

Chipset CMI8738 / PCI-6Ch form C-Media Technology System Interface 32bit PCI Bus Master, PCI 2.1 / PCI 2.2 compliant Hardware Interface Newest single chip 5.1 channel PCI sound audio solution HRTF-base 3D positional audio, supporting DirectSoundTM3D, EAX and A3D interface Karaoke system enabled Supports multi-speaker output to 2 / 2.1 / 4 / 4.1 / 5.1 speakers Support EAXTM, Karaoke key, Echo sound effects High Performance Dual Game Port MPU401 compatible MIDI interface & GM Comply with Microsoft PC99 specification DLS-base Wavetable music synthesizer Fully Sound Blaster, Sound Blaster Pro compatible and Direct Sound compatible Connector Front-Out, Rear-Out, Center & LFE, Line-In, MIC-In and Game/MIDI port CD Audio, AUX Connector

System Requirements
IBM compatible PC with 32-bit PCI slot. Microsoft Windows 98/98SE/ Me/ 2000/ XP/ NT4.0 / DOS or Linux Intel Pentium II 366MHz CPU above (Recommended) 32 MB system memory (Minimum) 100 MB available HDD space CD-ROM drive (or DVD-ROM drive Recommended)

Software Bundle
Multi-channel Speaker Tester WinDVD (Option) Powerful Audio Rack (CD / Midi / Wav / MP3 Player )

Package
Plug and Play PCI sound card User manual Installation Software CD-ROM

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

2. Installing the Sound Card

A. Hardware Installation
Before you start, make sure that Windows 98/98SE, Windows Me, Windows 2000/XP, Windows NT 4.0 or Linux has been installed in your system and running properly. Please follow the following steps carefully while installing your sound card. 1. Turn off your computer and disconnect all power cords. 2. Remove the case from your computer. Refer to your PCs user manual for more details. 3. Plug the Sound Card into any free 32-bit expansion PCI slot of the computer. 4. Connect the audio cable to your CD-ROM or DVD-ROM drive. 5. Put the computer cover case on and reconnect the power cords.

Connecting Audio Devices

You can connect various types of audio equipment, such as speakers, headphones, CD player and so on, to the sound card through its back panel jacks. The following diagram shows the connectors on the back panel. Layout of the Sound Maker Value 4.1 PCI Sound Card

AUX LINE IN M IC F-O ut R -O ut

C D -IN

J1 J10 J8 J9

J6

J3 J4

C M I8738/PCI-SX

G A M E /M ID I

JP2

llllllllllllllllllllllllllllllllll llllllll

Layout of the Sound Maker Value 5.1 PCI Sound Card

AU X C D -IN

LINE IN M IC F-O ut R -O ut C/LFE

J1 J10 J8

J11 J7

J6

J3 J4

JP1 J9 J12
C M I8738/PCI-6C H

JP3
1 5

G AM E /M ID I

JP2

llllllllllllllllllllllllllllllllll llllllll

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

LINE IN MIC F-Out R-Out C/LFE GAME/MIDI CD-IN

This connector provides Line-in function.

This connector provides Microphone-in function. This connector provides Front sound source output, you can connect one set of active speaker or headphone. This connector provides Rear sound source output, you can connect one set of active speaker or headphone. This connector provides Center & Subwoofer (LFE) sound source output, you can connect one set of active speaker.Value 5.1 only The 15-pin female connector can be connected to any IBM PC compatible joystick with a 15-pin D-shell connector and MIDI instrument. There are two sets of pins, one for Mitsumi standard and the other for Sony standard.

*A MIDI adapter is required to connect a MIDI instrument to the sound card. The MIDI adapter can be purchased from your local computer store and is connected to the MIDI/GAME port.

B. Drivers Setup
Auto Run
Auto Run for Windows 98 / Me / 2000 / XP / NT4.0, 1. Insert the Multimedia Software CD-ROM into your CD-ROM drive. 2. Click Sound Maker Value 4.1 or Sound Maker Value 5.1 button after entering software control panel. 3. Click Install Device Driver and Applications button.The wizard will lead you to finish all the installation. If Auto Run cant be used with your computer, please refer to each Windows as follows,

Installing the Sound Card Driver under Windows 98/98SE

1. After hardware installation has been finished, power up your computer and wait for Windows 95/98/98SE to boot up. 2. The message box will show Add New Hardware Wizard and This Wizard searches for new drivers for PCI Multimedia Audio Device. Click Cancel. 3. Insert the Multimedia Software CD-ROM into your CD-ROM drive or DVD-ROM drive. 4. Click Start at Windows bottom left corner. 5. Click Run. 6. Key in the drive and path for drivers/application installation program; for example, D:\SMVALUE4.1\SETUP.EXE or D:\SMVALUE5.1\SETUP.EXE. (If your CD-ROM drive or DVD-ROM drive is D) 7. Click OK to start the applications/driver installation procedure, and follow the on-screen instructions to finish the installation. 8. When all the application software has been installed, please restart your computer. 9. Your system will install device drivers automatically.

Installing the Sound Card Driver under Windows Me

1. After hardware installation has been finished, power up your computer and wait for Windows Me to boot up. 5

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

2. The message box will show Add New Hardware Wizard and Windows has found the following new hardware for PCI Multimedia Audio Device. Click Cancel. 3. Insert the Multimedia Software into your CD-ROM drive or DVD-ROM drive. 4. Click Start at Windows bottom left corner. 5. Click Run. 6. Key in the drive and path for drivers/application installation program; for example, D:\SMVALUE4.1\SETUP.EXE or D:\SMVALUE5.1\SETUP.EXE. (If Drive D is your CD-ROM drive or DVD-ROM drive) 7. Click OK to start the applications/driver installation procedure, and follow the on-screen instructions to finish the installation. 8. Restart your computer. 9. Your system will search for new drivers installation. System will install device drivers automatically. 10. When all drivers have been installed, your system will continue to install the application software. When all the application software has been installed, please restart your computer.

Installing the Sound Card Driver under Windows 2000/XP

We recommend you to install Microsoft Windows before you install this PCI sound card, and ensure you didnt install any other sound card device drivers in your current system. 1. After hardware installation has been finished, power up your computer and wait for Windows 2000 to boot up. 2. The message box will show Found New Hardware Wizard Click Cancel. 3. Insert the Multimedia Software into your CD-ROM drive or DVD-ROM drive. 4. Click Start at Windows bottom left corner. 5. Click Run. 6. Key in the drive and path for drivers/application installation program; for example, D:\SMVALUE4.1\SETUP.EXE or D:\SMVALUE5.1\SETUP.EXE. (If Drive D is your CD-ROM drive or DVD-ROM drive) 7. Click OK to start the applications/driver installation procedure, and follow the on-screen instructions to finish the installation. 8. When all drivers have been installed, please restart your computer. 9. Your system will continue to install the application software. When all the application software has been installed, please restart your computer.

Installing the Sound Card Driver under Windows NT 4.0

We recommend that you install Windows NT 4.0 before you install this PCI audio card, and ensure you didnt install any other sound card device drivers in your current system. 1. After hardware installation has been finished, power up your computer and wait for Windows NT 4.0 to boot up. 2. Click Start, Select Settings, and click the Control Panel. 3. Double-click Multimedia. 4. Select Devices, and press Add. 5. Select Unlisted or Updated Driver in List of Drivers then click OK. 6. Specify the drive and the path where NT drivers are in (such as D:\Smvalue4.1\Win_NT40\Drv or D:\Smvalue5.1\Win_NT40\Drv). 7. Select C-Media PCI Device and click OK. 8. Select proper I/O value. 9. Press OK. 10. Restart the system. 11. Now, you have already installed the PCI Audio driver under Microsoft Windows NT 4.0 6

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

successfully. If you want to install the Windows applications, continue the following steps: 12. Click Start. 13. Select Run. 14. Key in drive and path for Windows NT application installation program; for example, D:\Smvalue4.1\Win_NT40\App\Setup.exe or D:\Smvalue5.1\Win_NT40\App\Setup.exe. 15. Click OK to start the installation procedures, and follow the on-screen instructions to finish the installation. When all of application software has been installed, shut down the Windows NT system and then reboot your system.

Uninstalling the Sound card Driver for Windows NT 4.0

1. 2. 3. 4. 5. 6. 7. 8. Press "Start" button. Select "Settings" and click "Control Panel". Double click on "Multimedia" icon. Select "Devices" page. Open "Audio Devices". Select "Audio for C-Media PCI Device" then press "Remove" button. Press "Yes" button while system ask for confirming. Shut down NT system and reboot.

Installing the Sound Card Driver under Linux

1. Please check the detail steps from folder D:\Smvalue4.1\Linux\Readme file or D:\Smvalue5.1\Linux\Readme file.

Installing the Sound Card Driver under DOS

1. Insert the Multimedia Software into your CD-ROM drive or DVD-ROM drive. 2. Change directory to DOS driver folder (D:\Smvalue4.1\Dosdrv or D:\Smvalue5.1\Dosdrv) at DOS prompt, and type INSTALL. Click Enter. 3. Type DOS utilities path that you want to install the file in. 4. Program will expand the file to the path youve specified. 5. Install program will add initial drivers into AUTOEXEC.BAT file.

Uninstalling the Sound card Applications & Driver for Windows 98/Me/2000/XP
1. 2. 3. 4. 5. 6. 7. Click Start. Select Settings. Select Control Panel and click Add/Remove Program Double click PCI Audio Applications and than click OK Follow the on-screen instructions to uninstall the applications Return to Add/Remove Program Double click PCI Audio Driver and than click OK Follow the on-screen instructions to uninstall the Audio Driver, then reboot your system

C. Other Application Setup

Installing Sound Application WinDVD (Option)
1. Insert the Multimedia Software CD-ROM and double-click Setup.exe in the directory D:\WinDVD\. (If Drive D is your CD-ROM drive or DVD-ROM drive) 2. Follow the instruction on the screen to install software for PCI sound card. 7

PCI Sound CardSound Maker Value 4.1/5.1 Sound Card

Appendix A. Hardware Information

Jp3 : Center and Subwoofer setting selectionSound Maker Value 5.1 Only Close
(3,5) (1,3) (4,6) (2,4)

Function
C/LFE (DEF) LFE/C