Scribd
Upload
51 views1 page

Experiment Setup Model

The experimental setup was designed to predict the behavior of thin concrete slabs under loading until failure. Three concrete slab specimens with dimensions of 0.95x1.45x0.10 meters and reinforced with 8mm diameter rebar spaced 150mm apart were constructed and tested at 7, 14, and 21 days to analyze changes in behavior over time. Materials used included concrete with a mix ratio of 1:1.5:3, steel reinforcement, formworks, strain gauges, and a loading setup.

Uploaded by

nirmaljoshi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
51 views1 page

Experiment Setup Model

The experimental setup was designed to predict the behavior of thin concrete slabs under loading until failure. Three concrete slab specimens with dimensions of 0.95x1.45x0.10 meters and reinforced with 8mm diameter rebar spaced 150mm apart were constructed and tested at 7, 14, and 21 days to analyze changes in behavior over time. Materials used included concrete with a mix ratio of 1:1.5:3, steel reinforcement, formworks, strain gauges, and a loading setup.

Uploaded by

nirmaljoshi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Experimental setup for perdicting behaviour of thin slab

-Joshi Nirmal Raj P=0 to failure rebar 8mm @150 mm c/c concrete (1:1.5:3)

0.1000

Section A-A
0.2500 0.2500 0.9500 0.2500

Loading setup

1.4500

Material required
Concrete Steel (8mm) Binding wire Formworks Strain gauge reinforcement grid For 1spec. 0.079m3 9.90 m as required 0.40 m2 9 nos For 3 spec 0.239 m3 29.70 m 1.20 m2 27nos

0.5500

Number of specimen Test sequence

3 nos 7 days, 14 days, 21 days

PLAN

You might also like