Scribd
Upload
87 views8 pages

Sine Bar Lesson

The sine bar is a precision tool used for measuring or checking angles with an accuracy of 5 minutes or less. It works by locating a workpiece at a given angle using the height of the sine bar, which can be found using gauge blocks and references in machining handbooks. The document provides instructions on setting up a 5-inch sine bar to measure various angles between 10 and 36 degrees.

Uploaded by

Saravana Pandiyan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
87 views8 pages

Sine Bar Lesson

The sine bar is a precision tool used for measuring or checking angles with an accuracy of 5 minutes or less. It works by locating a workpiece at a given angle using the height of the sine bar, which can be found using gauge blocks and references in machining handbooks. The document provides instructions on setting up a 5-inch sine bar to measure various angles between 10 and 36 degrees.

Uploaded by

Saravana Pandiyan
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 8

INTRODUCTION TO SINE BAR

SINE BAR USE

The sine bar is used either for very accurate angular measurements or for locating work at a given angle. The sine bar is especially useful in measuring or checking angles when the limit of accuracy is 5 minutes or less

SAMPLES OF SINE BAR

Terms and Symbols


Diameter: Angle: < Height: H Radius: R. Degrees:

SETTING UP A 5-INCH SINE BAR TO GIVEN ANGLE

TOOLS NEEDED

SURFACE GROUND GRANITE TABLE

HEIGHT GAUGE

GAUGE BLOCKS

REFER TO MACHINIST HAND BOOK pg 1366 or 1121

FIND THE HEIGHT FOR THE FOLLOWING ANGLES


1011= ________ 1530=_________ 2245= _________ 3218=__________ 36 41=__________

You might also like