Scribd
Upload
21 views5 pages

Quartus 2 Operation Procedure v1

The document provides steps for using Quartus 2 software to create a new project, add AHDL coding files, and generate a waveform file to simulate and view output signals. It involves setting up a new project location, creating files, entering code, saving work, and generating a waveform with inserted nodes to view signal behavior over time. The steps guide the user through basic Quartus operations to set up, code, and simulate a simple design.

Uploaded by

Htet Mrak Aung
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
21 views5 pages

Quartus 2 Operation Procedure v1

The document provides steps for using Quartus 2 software to create a new project, add AHDL coding files, and generate a waveform file to simulate and view output signals. It involves setting up a new project location, creating files, entering code, saving work, and generating a waveform with inserted nodes to view signal behavior over time. The steps guide the user through basic Quartus operations to set up, code, and simulate a simple design.

Uploaded by

Htet Mrak Aung
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Quartus 2 Operation Procedure (Part 1) Step 1 Click File followed by New Project Wizard and Next

Step 2 Change the C:\altera\81\quartus to C:\altera\project1 and add in file name as Lab1

Step 3 Click Finish

Click Yes Step 4 Click File followed by New and AHDL file, OK Step 5 Enter your AHDL coding. Step 6 Click File followed by Save. Step 7 Click

Wait until you see

Please ignore all the warnings. Click OK.

Quartus 2 Operation Procedure (Part 2) Step 1 Click File followed by New and Vector Waveform File, OK Step 2 Click Edit followed by End Time Example: 650ns OK

Step 3 Click Edit followed by Grid size Example: 25ns OK

Step 4 Click View followed by Fit in window Step 5 Click Edit followed by Insert followed by Insert Node or Bus

Click Node Finder

Step 6 Click List and select clk, ss, y and z By clicking the column. to cross them over to right hand

Click OK 2X
4

Step 7 click clk followed by

and OK

Step 8 click and drag the input y (200ns to 400ns)

Click

Step 9 Click File and Save Step 10 Click

Please ignore all the warnings. Click OK.


5

You might also like