Scribd
Upload
68 views

Proe Animations - Guide For Me170

The document provides instructions for animating a simple pneumatic cylinder model in ProE. It describes how to assemble the cylinder parts, create snapshots of the mechanism at different positions, and set those snapshots as key frames in an animation with intervals of up to 10 seconds. The animation can then be played, controlled, and viewed to check the motion of the pneumatic cylinder.

Uploaded by

Karthik Srinivas
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views

Proe Animations - Guide For Me170

The document provides instructions for animating a simple pneumatic cylinder model in ProE. It describes how to assemble the cylinder parts, create snapshots of the mechanism at different positions, and set those snapshots as key frames in an animation with intervals of up to 10 seconds. The animation can then be played, controlled, and viewed to check the motion of the pneumatic cylinder.

Uploaded by

Karthik Srinivas
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

ProE Animations Guide for ME170 By: Mike Philpott Animate the following simple pneumatic cylinder. 1.

. Assemble the 2 parts together using a cylinder or slider connection (see Joint Connections attached)

2. Create snapshots at intervals desired. Use the icon to click and drag the mechanism to the desired locations. Expand the snapshots dialog box to view and record the snapshots:

Use the camera

icon to record each snapshot. You can view, move to and check .

each snapshot with the spectacle icon

3. When you are happy with the snapshots, enter animation mode by Applications -> Animation on the top ProE menu bar. 4. Create the Key frame sequence (KFS) with the film strip icon allows you to add each snapshot with the total of 10 units (ie seconds). . The dialog box

icon at different time intervals up to a

5. Now you can start the animation with the start icon

and wait for it to run through .

once. After this initialization you can use the movie icon to fully control playback

You might also like