Scribd
Upload
94 views2 pages

Warping 2 Threads With A 1-And-1 Cross: Start Peg Cross Peg #1 Cross Peg #2

The document provides instructions for warping 2 threads in a 1-and-1 cross pattern on a warping board. The instructions include: 1) Starting with the green thread on top at the start peg; 2) Placing the threads on the first cross peg with green on top; 3) Shifting positions and placing on the second cross peg; 4) Continuing around the board, shifting positions of the threads at each cross peg.

Uploaded by

Annabelle Rigat de Leon
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
94 views2 pages

Warping 2 Threads With A 1-And-1 Cross: Start Peg Cross Peg #1 Cross Peg #2

The document provides instructions for warping 2 threads in a 1-and-1 cross pattern on a warping board. The instructions include: 1) Starting with the green thread on top at the start peg; 2) Placing the threads on the first cross peg with green on top; 3) Shifting positions and placing on the second cross peg; 4) Continuing around the board, shifting positions of the threads at each cross peg.

Uploaded by

Annabelle Rigat de Leon
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Warping 2 threads with a 1-and-1 cross

Start peg Cross peg #1 Cross peg #2

Two colors are used here (green and white) to show how the 2 threads maintain their positions. 1. To start winding, tie a knot in the ends of the 2 threads and put the knotted loop around the Start peg and insert your index finger in the loop with the green thread on top and the white on the bottom and your finger pointing toward the wall.

2. Carrying the 2 threads this way, place them on Cross peg #1, green on top, white underneath.

6. On the return back to the cross pegs, when you come up around the top outside peg on the right, shift your hand (a counterclockwise turn) to put the white thread on top (I also sort of stick my thumb in the opening to spread it a bit) and carry this opening toward Cross peg #2. 3. Shift your hand in a clockwise turn so that the threads change position, white thread on top but closest to you, green thread on bottom.

7. Place this opening over Cross peg #2 (white thread on top, green thread on bottom). 4. Place the threads in this position on Cross peg #2. 5. Then turn your hand back (a counterclockwise turn) and go around the warping board as usual, carrying both threads and keeping your index finger always between them.

8. Shift your hand back (youll be turning it clockwise) so that the green thread is now on top, the white thread on the bottom; make sure that the white thread is closest to you.

10. Turn your hand a small amount counterclockwise and take both threads around the bottom of the Start peg (with your index finger still between them as always) to be ready to start again.

9. Place this opening over Cross peg #1. 11. Turn your hand a small amount clockwise to make the opening for Cross peg #1 on the next round.

You might also like