100% found this document useful (2 votes)
1K views2 pages

Experiment Name-Study of Phase Shift Oscillator

The document describes an experiment on studying a phase shift oscillator circuit. The objective is to construct an R-C phase shift oscillator and measure its theoretical and actual frequencies. The circuit diagram and components required are provided. The procedure describes building the circuit, measuring output frequency and phase shifts, and modifying it to a C-R oscillator. Questions are also given regarding operation and characteristics of the phase shift oscillator.

Uploaded by

mrana_56
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100% found this document useful (2 votes)
1K views2 pages

Experiment Name-Study of Phase Shift Oscillator

The document describes an experiment on studying a phase shift oscillator circuit. The objective is to construct an R-C phase shift oscillator and measure its theoretical and actual frequencies. The circuit diagram and components required are provided. The procedure describes building the circuit, measuring output frequency and phase shifts, and modifying it to a C-R oscillator. Questions are also given regarding operation and characteristics of the phase shift oscillator.

Uploaded by

mrana_56
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

American International University Bangladesh (AIUB) Faculty of Engineering

Analog Electronics 2 (LAB)

Experiment # 08 Experiment name: Study of Phase Shift Oscillator


Objective: A typical R-C phase shift oscillator will be constructed and studied in this experiment. The theoretical frequencies of the oscillation are: 6 For R-C Oscillator 2RC

1 2RC
Circuit Diagram:

1 6 4( RC R)

For C-R Oscillator

6V

RC POT 100 K

2.7 K

10 uf + 1K R 1K R 1K R

C828

Vin, Channel 1

R2

3K

RE 2.7 K 100 uf

C 0.01 uf

C 0.01 uf

C 0.01 uf

Equipment required: 1. 2. 3. 4. Transistor (C828) DC Power Supply Oscilloscope Resistors a. 1 K 3 b. 2.7 K 2 c. 3 K 1 d. 33 K 1 e. 100 K (POT)1 f. 100 1

Vout, Channel 2

5. Capacitors a. 0.01 F b. 10 F

3 3

Procedure: 1. Connect the circuit as shown in the figure for R-C phase shift oscillator. 2. Vary the 100K POT to have the undistorted sine wave at the output terminal. 3. Determine the frequency of output and verify it with the theoretical frequency. 4. Determine the phase shift of the input and output signal. To so this, connect both the channels and operate the oscilloscope in XY mode. 5. Reconnect the circuit for C-R oscillator by interchanging the R and C elements. 6. Repeat steps 2, 3 and 4. Report: 1. Why R-C oscillator is called phase shift oscillator? 2. Why there is discrepancy between the observed and theoretical frequency? 3. How the amplitude and the frequency of oscillator ca be changed? 4. What type of feedback is used in the oscillator circuit? 5. What is frequency range of R-C oscillator? 6. Derive the above two equations.

You might also like