Scribd
Upload
504 views1 page

737ng Manual AFDS Module AFD1075

The document provides instructions for connecting and using an autopilot flight director system module designed for desktop flight simulators. It includes a wiring diagram and lists terminal connections for inputs, outputs, and power. Users are advised to carefully read instructions before connecting due to the sensitivity of electronic parts.

Uploaded by

crickdcricket
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
504 views1 page

737ng Manual AFDS Module AFD1075

The document provides instructions for connecting and using an autopilot flight director system module designed for desktop flight simulators. It includes a wiring diagram and lists terminal connections for inputs, outputs, and power. Users are advised to carefully read instructions before connecting due to the sensitivity of electronic parts.

Uploaded by

crickdcricket
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

AFD1075

Autopilot Flight Director System

AFDS
Congratulations on your purchase of the FLYENGRAVITY AFDS module. We advice to carefully read the instructions prior to making any connections. The AFDS module is designed for the MIP desktop series and MIP Pro. NOTE: Please read the CP-Flight MIP737 Manual before proceed to connect the wiring !

Wiring diagram
The numbers mentioned below refer to the terminals on the MIP board. Always check the manual first To positive 12V Ground 12V LED Common 11 and 41 Switch input 16 (Cap+Copilot) Switch input 15 (Cap+Copilot) Switch input 14 (Cap+Copilot) Switch input 13 (Cap+Copilot) LED output 16 and 46 LED output 17 and 47 LED output 14 and 44 LED output 15 and 45 LED output 13 and 43 to positive 12V (backlight) Ground 12V (backlight) Switch input 26 and 80 Switch input 24 and 78 Switch input 25 and 79

Electronic parts are sensitive devices, always make sure what you do when connecting and use the proper tools. In case of doubt, please contact our support department at [email protected] The AFD1075 is designed to be used with the CP flight MIP board.

FLY

ENGRAVITY www.engravity.com
Engravity BV 2009

PUSH COM FMC R A A/P A/P A/T 0V 0V

LED R A A/T COM BL + FMC BL -

TEST UP

+12V

DWN

You might also like