Scribd
Upload
191 views1 page

LabVIEW Voice Over Internet Protocol

The document outlines the software requirements and procedures for making VOIP calls using LabVIEW. To make a call, the caller enters the recipient's IP address and clicks connect. If the recipient accepts the call, the connected LED lights up and conversation can begin. After talking, each person clicks disconnect. To cancel an incoming call, the recipient clicks discard when the incoming call LED blinks.

Uploaded by

vhurtadolara
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
191 views1 page

LabVIEW Voice Over Internet Protocol

The document outlines the software requirements and procedures for making VOIP calls using LabVIEW. To make a call, the caller enters the recipient's IP address and clicks connect. If the recipient accepts the call, the connected LED lights up and conversation can begin. After talking, each person clicks disconnect. To cancel an incoming call, the recipient clicks discard when the incoming call LED blinks.

Uploaded by

vhurtadolara
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

LabVIEW Voice over internet protocol (VOIP) Software Requirements 1.

All parties must have a sound enabled computer with a microphone and speakers Procedure To make a call, enter the ip of the computer you want to call and click connect. On the recipients side the Incoming Call LED begins to blink. The recipient then clicks Accept. Once the recipient has clicked Accept the caller will see the connected LED come on. At this point the connection has been established and conversation may commence. After the conversation each person should click the Disconnect button to be disconnected. In order to cancel an incoming call click Discard when the Incoming Call led begins to blink. Contact [email protected]

You might also like