Scribd
Upload
251 views2 pages

Practice Question For DEN 331

1) The document describes a fluid flow simulation between two parallel plates using Fluent software. 2) It models water flow between plates that are 1cm apart and 20cm long, with an inlet and outlet. 3) It prompts the reader to consider questions about convergence criteria, mesh refinement, plotting pressure contours and velocity vectors, validating results against analytical solutions, and the effects of mesh type and solver order.

Uploaded by

Mohammad Inam Lone
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
251 views2 pages

Practice Question For DEN 331

1) The document describes a fluid flow simulation between two parallel plates using Fluent software. 2) It models water flow between plates that are 1cm apart and 20cm long, with an inlet and outlet. 3) It prompts the reader to consider questions about convergence criteria, mesh refinement, plotting pressure contours and velocity vectors, validating results against analytical solutions, and the effects of mesh type and solver order.

Uploaded by

Mohammad Inam Lone
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

DEN 331 Computer Aided Engineering for Solids and Fluids Prof John Williams 2012-2013 Problem description

(Remember this is designed only for your practice not the question for the course or!" #tudy the steady fluid flo bet een t o parallel infinite plates using the commercial soft are $luent and %&'() *ssume the fluid to be ater-liquid is a+ailable in $luent material database) hich

%nle t 0)03cm
.s

Wall 1
1 cm

20c m

outle t

Wall 2

Think about the follo ing !uestions" 1") ,o do you !no you model has reached con+ergencehat is the effect on simulation

2") ,o to increase.reduce mesh density and accuracy3") ,o to dra

the static pressure contour and +elocity +ector fieldith analytical

/") ,o to 0udge the accuracy of your modelling- (&lue1 compare solutions) 2his is not a cylinder") 3") ,o to plot the all shear on the compare ith analytical solution") all- %s this

hat you e4pect- (&lue1 again

5") Will the unstructured mesh produce the same results6") Will the 2nd order sol+er produce the same results-

You might also like