Scribd
Upload
347 views

Additional Formula For Machine Design

The document contains formulas related to mechanical engineering concepts such as bolts, power screws, shafts, springs, gears, clutches, and brakes. Equations define relationships between variables such as power and speed, lead and diameter, stress and set screw properties, linear and angular speed, torque and inertia for stopping rotation, force and deflection for springs, tooth properties for gears, torque and inertia for clutches, and forces and angles for cones.

Uploaded by

userako21
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
347 views

Additional Formula For Machine Design

The document contains formulas related to mechanical engineering concepts such as bolts, power screws, shafts, springs, gears, clutches, and brakes. Equations define relationships between variables such as power and speed, lead and diameter, stress and set screw properties, linear and angular speed, torque and inertia for stopping rotation, force and deflection for springs, tooth properties for gears, torque and inertia for clutches, and forces and angles for cones.

Uploaded by

userako21
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

From No.

17
Square Thread

Bolts and Power Screw


From No. 6

where: hp = power, hp N =angular speed, rpm D = shaft diameter, in d = set screw diameter, in

Where: L = Lead Di = Root Diameter N = angular speed, rpm L = Lead, ft or m/min

Shaft
From No. 2a

a = sensitivity factor r = radius stress raiser Where: q = 0.983 n = no. of set screw, dn = diameter in inches per no. Shaft of set screw From No. 12

V = NL
V = linear speed in raising the screw, ft/min or m/min

where: hp = horsepower D = Diameter of shaft, inch N = angular speed, rpm

Brakes (From No. 2) T = average torque to stop the rotation, lb-ft I = Inertia Load, lb-ft2 = angular acceleration, rad/sec2 g = gravitational acceleration = 32.2 ft/sec2 T = average torque to stop the rotation, lb-ft wr2 = Inertia Load, lb-ft2 N =angular speed, rpm t = time, sec Where: h = height of the object, m or ft W = weight of the object, N or lb k = spring rate, N/m or lb/ft = deflection of spring, m or ft Pd = Diametral Pitch, teeth/diameter C = Center distance T1 = No. of Teeth 1 T2 = No. of Teeth 2

Spring

Gear (From No. 5)

Clutch (From No. 3)

T = clutch starting torque, lbft I = Inertia Load or mass inertia, lb-ft2 = angular acceleration, rad/sec2 g = gravitational acceleration = 32.2 ft/sec2 T = clutch starting torque, lbft wr2 = Inertia Load or mass interia, lb-ft2 N =angular speed, rpm t = time, sec F = Force on the clutch Dm = Mean Diameter S = allowable stress Fa = axial Force, N or lb ) = cone angle, degrees Fn = Normal Force, N or lb

From No. 7

You might also like