Scribd
Upload
126 views1 page

Man B&W 11.02: Central Cooling Water System

The central cooling water system has one heat exchanger cooled by seawater that cools other coolers like the jacket water cooler. The cooling water design temperature is normally 36°C when seawater is 32°C to prevent high scavenge air temperatures. The temperature control valve should be set to a minimum of 10°C so cooling water temperature follows seawater temperature when above 10°C. Maximum water velocities are specified for connections to parts like the jacket water and central cooling water systems.

Uploaded by

mavericksailor
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
126 views1 page

Man B&W 11.02: Central Cooling Water System

The central cooling water system has one heat exchanger cooled by seawater that cools other coolers like the jacket water cooler. The cooling water design temperature is normally 36°C when seawater is 32°C to prevent high scavenge air temperatures. The temperature control valve should be set to a minimum of 10°C so cooling water temperature follows seawater temperature when above 10°C. Maximum water velocities are specified for connections to parts like the jacket water and central cooling water systems.

Uploaded by

mavericksailor
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

MAN B&W

11.02
Page 1 of 1

Central Cooling Water System


The central cooling water system is characterised by having only one heat exchanger cooled by seawater, and by the other coolers, including the jacket water cooler, being cooled by central cooling water. In order to prevent too high a scavenge air temperature, the cooling water design temperature in the central cooling water system is normally 36 C, corresponding to a maximum seawater temperature of 32 C. Our recommendation of keeping the cooling water inlet temperature to the main engine scavenge air cooler as low as possible also applies to the central cooling system. This means that the temperature control valve in the central cooling water circuit is to be set to minimum 10 C, whereby the temperature follows the outboard seawater temperature when central cooling water temperature exceeds 10 C. For external pipe connections, we prescribe the following maximum water velocities: Jacket water................................................. 3.0 m/s Central cooling water................................... 3.0 m/s Seawater...................................................... 3.0 m/s

Expansion tank central cooling water PT 8421 AL TI 8431 TE 8431 I AL These valves to be provided with graduated scale

Seawater outlet

Regarding the lubricating oil coolers, this valve should be adjusted so that the inlet temperature of the cooling water is not below 10 C Air pockets, if any, in the pipe line between the pumps, must be vented to the expansion tank

TI TI TI Central cooler Lubricating oil cooler TI N AS P

PI Seawater pumps

TI

PI

TI Central cooling water pumps Jacket water cooler TI Main engine

PI

Cooling water drain air cooler

Seawater inlet

Seawater inlet Jacket cooling water Sea water Fuel oil The letters refer to list of Counterflanges, Fig. 5.10.01 The item No. refer to Guidance values automation
178 52 771.1

Fig. 11.02.01: Central cooling water system

MAN B&W MC/MCC, ME/MEC/MEGI/ME-B engines

MAN Diesel

198 40 579.5

You might also like