Scribd
Upload
285 views2 pages

Assignment 4 Isometric

This document provides instructions for Assignment-4 of the course EMD 101 Engineering Drawing. Students are asked to draw isometric views of four different parts labeled Part-A1 through Part-A4 and one part labeled Part-B1 on an A3 size paper at a 1:1 scale. All dimensions must be included and referenced to point A. Drawings are due on October 18, 2013 by 12 noon.

Uploaded by

Jamaliah Ahmad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
285 views2 pages

Assignment 4 Isometric

This document provides instructions for Assignment-4 of the course EMD 101 Engineering Drawing. Students are asked to draw isometric views of four different parts labeled Part-A1 through Part-A4 and one part labeled Part-B1 on an A3 size paper at a 1:1 scale. All dimensions must be included and referenced to point A. Drawings are due on October 18, 2013 by 12 noon.

Uploaded by

Jamaliah Ahmad
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

EMD101EngineeringDrawing SEMI2013/2014

Assignment4:Isometric DueDate:18October2013,12noon 1. UseA3sizepaperonly. 2. Draw the isometric view of the parts given. All units given are in millimeter. Draw at the scaleof1:1. 3. UsetheApointastheoriginofyourisometricdrawing. 4. Include complete dimensions in all your isometric drawings. Please refer to textbook or noteforproperdimensioninginisometricprojectionview. PARTA

PartA1:DovetailSlide

A PartA2:SupportBracket

A A

A A PartA3:MachinedBlock
Dr. Abdus

PartA4:SquareShaftLink

EMD101EngineeringDrawing SEMI2013/2014

PARTB

PartB1:MountingBracket

Dr. Abdus

You might also like