Scribd
Upload
550 views2 pages

Half-Bridge and Full-Bridge Converters Half-Bridge Converter

The document discusses and compares half-bridge and full-bridge converter circuits. A half-bridge converter uses two capacitors with half the DC input voltage across each, and switches the voltage across the primary winding alternately using two MOSFETs. A full-bridge converter uses four MOSFETs switched in pairs to apply the full DC voltage across the primary winding. The full-bridge converter outputs twice the voltage of the half-bridge converter but requires simpler gate drive circuits for the MOSFETs. Both converter circuits aim to step up or down voltage efficiently from DC to AC through a transformer.

Uploaded by

veerusite
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
550 views2 pages

Half-Bridge and Full-Bridge Converters Half-Bridge Converter

The document discusses and compares half-bridge and full-bridge converter circuits. A half-bridge converter uses two capacitors with half the DC input voltage across each, and switches the voltage across the primary winding alternately using two MOSFETs. A full-bridge converter uses four MOSFETs switched in pairs to apply the full DC voltage across the primary winding. The full-bridge converter outputs twice the voltage of the half-bridge converter but requires simpler gate drive circuits for the MOSFETs. Both converter circuits aim to step up or down voltage efficiently from DC to AC through a transformer.

Uploaded by

veerusite
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Half-bridge and full-bridge converters Half-bridge converter Figure 12 is a circuit diagram of a half-bridge converter.

Two capacitors C1 and C2 have half of d.c. input voltage across of each. The voltage, 0.5 V1 is switched across the primary winding by MOSFET T1 and T2 alternately. The switch that is off will have the full d.c. voltage across it. The output voltage Vo is:Vo = V1 x D x (Ns/Np)

Figure 12 - Half bridge converter Some of advantages of half bridge converters are:

Small magnetic cores. No magnetic path gap therefore low stray magnetic field. Frequency seen by secondary circuits is double the basic switching frequency - small filter components (L and C) in secondary circuits. Low output ripple and noise. Multiple output configurations easily implemented. Relatively low radiated noise, especially if the secondary inductors are toroidal cores.

A disadvantage is because they are working at half the supply voltage the switching transistors are working at twice the collector current compared with the basic push pull circuit. Full bridge converter In Figure 13, this is a full-bridge converter circuit diagram. T1 and T3 is a pair, they are switched on simultaneously, while T2 and T3 is followed simultaneously. At least two of the bridge transistors require gate isolation circuits. The output voltage, Vo is twice that of the half-bridge: Vo = 2 x V1 x D x (Ns/Np)

Figure 13 - Full bridge converter The much simpler and lower power gate drive circuits required by MOSFETS when compared with complex base drive requirements of bipolar transistors switches greatly favours their use in high power full bridge circuits. MOSFETS gives considerable size advantages in the transformer core and in filter components. This is well illustrated by referring to the Power Ten range of high power rack mounted units.

You might also like