Scribd
Upload
309 views1 page

2 Inch WG Table

The document outlines duct construction standards for galvanized, 304 stainless steel, and 316 stainless steel ductwork. It specifies the appropriate duct gauge, joint length, and type of connector to use for different duct sizes. For duct sizes between 0-12 inches, the recommended duct gauge is 26, joint length is 59 inches, and wide side connector is a flat slip. Larger duct sizes use thicker duct gauges, shorter joint lengths, and reinforced tie rod connectors.

Uploaded by

shankarniceguy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
309 views1 page

2 Inch WG Table

The document outlines duct construction standards for galvanized, 304 stainless steel, and 316 stainless steel ductwork. It specifies the appropriate duct gauge, joint length, and type of connector to use for different duct sizes. For duct sizes between 0-12 inches, the recommended duct gauge is 26, joint length is 59 inches, and wide side connector is a flat slip. Larger duct sizes use thicker duct gauges, shorter joint lengths, and reinforced tie rod connectors.

Uploaded by

shankarniceguy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2" 1" W.G. Static Pos. or Neg.

SHOP STANDARDS DUCT CONSTRUCTION TABLE (FOR GALVANIZED & 304 S.S. & 316 S.S. DUCTWORK) (NOT FOR ALUMINUM)

DUCT SIZE 0" - 12" 13" - 30" 31" - 54" 55" - 84" 85" & above Plenum

DUCT GAUGE 26 24 22 20 18 18

JOINT LENGTH 59" 59" 56" 56" 56" 56"

WIDE SIDE CONNECTOR Flat Slip T-6 24 GA Standing Slip T-11 26 GA T.D.C. T-25a T.D.C. T-25a T.D.C. w/C.T.R. & J.T.R. T-25a T.D.C. w/C.T.R. & J.T.R. T-25a

NARROW SIDE CONNECTOR Flat Drive T-1 24 GA Flat Drive T-1 24 GA T.D.C. T-25a T.D.C. T-25a T.D.C. w/C.T.R. & J.T.R. T-25a T.D.C. w/C.T.R. & J.T.R. T-25a

SPECIAL NOTES Ref. 1 Ref. 1 Ref. 1 Ref. 1 Ref. 2 Ref. 1

NOTES: J.T.R. - JOINT TIE ROD C.T.R. - CENTER TIE ROD TIE RODS ARE 1/2" EMT If MPT (Mid-point Tie Rods) are used, the reinforement spacing is based on 2 1/2" References:
1. SMACNA-HVAC Duct Construction Standards Metal and Flexible, Second Edition 1995, page 1-20, Table 1.4 2. SMACNA-HVAC Duct Construction Standards Metal and Flexible, Second Edition 1997, Addendum 1, page 1-41.6 Table 1-45

2519 Monroe Drive; Gainesville, GA 30507 Phone: 770-532-9130. Fax: 770-287-1870

You might also like