Scribd
Upload
17K views22 pages

Telecommunication Switching System Networks PDF

The document discusses several key topics in telecommunication networks including standards, analog networks, integrated digital networks, integrated services digital networks, cellular radio networks, intelligent networks, private networks, numbering plans, charging plans, routing plans, and network management. Standards were developed to enable interoperability between networks. Early analog networks evolved to use digital technologies, fiber optics, and time division switching. Integrated digital networks provided more services and routing flexibility.

Uploaded by

Udhay Prakash
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17K views22 pages

Telecommunication Switching System Networks PDF

The document discusses several key topics in telecommunication networks including standards, analog networks, integrated digital networks, integrated services digital networks, cellular radio networks, intelligent networks, private networks, numbering plans, charging plans, routing plans, and network management. Standards were developed to enable interoperability between networks. Early analog networks evolved to use digital technologies, fiber optics, and time division switching. Integrated digital networks provided more services and routing flexibility.

Uploaded by

Udhay Prakash
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

Networks

Telecommunication Data communication INTEGRATED services


UDHAY PRAKASH P Uday3prakash @gmail.com
10/19/2012 TSSN 4ECE JNTUHCEH 1

Standards for networks


Standards were deserved to make inter-operability between the networks of various nations. Standardizations include standards for:
Transmission plan Charging Plan Signaling Plan Numbering Plan Routing Plan Grade of service Capabilities of switching equipment Network management All these parameters are not independent, but inter-related.

10/19/2012

TSSN

4ECE JNTUHCEH

Standards for networks


Network planning was done to equalize the tradeoff between performance and cost. It is economical to provide circuits more generously where they are cheap(Customer-access circuits) and less generously where they are expensive(Trunk

circuits).

10/19/2012

TSSN

4ECE JNTUHCEH

Analog Networks
Number of levels in hierarchy of a PSTN depends on the relative costs
of transmission and switching in that network.

Small and densely populated countries has shorter distances between its primary centers and large 10/19/2012 TSSN amount of traffic between them.

4ECE

Large or sparsely populated countries has longer distances between its primary centers and relatively less JNTUHCEH 4 traffic between primaries.

Analog Networks
Large networks were later divided into:
1. Long distance carriers, called as Interexchange carriers(IXC). 2. Local-access and transport areas(LATA) belonging to local Exchange carriers(LEC).

Each IXC interfaces with a LATA directly to a single point, called point of presence(pop) or routed via an access tandem(AT).
10/19/2012 TSSN 4ECE JNTUHCEH 5

Integrated Digital Network


Analog Networks Digital Networks

Low capacity copper cables---high capacity optical fibers. Electromechanical analog space division switching systemElectronic digital time division switching Channel associated signaling--common channel signaling. Reduced network configuration More than one connection to the upper level of hierarchy

10/19/2012

TSSN

4ECE JNTUHCEH

Integrated Digital Network


Many small exchanges are replaced by multiplexers and the remote concentrators, resulting in fewer large capacity junction routes.

10/19/2012

TSSN

4ECE JNTUHCEH

Integrated Digital Network


It is a non-hierarchical network, which uses dynamic alternative routing. Here, one class of tandem switching

centre replaces both the sectional and


regional centers of traditional analog system.

10/19/2012

TSSN

4ECE JNTUHCEH

Integrated Digital Network


Switching Network Data links used for common channel signalling between digital exchanges form a separate signalling networks. As signalling network uses transmission bearer network channels, synchronizing network is deserved to synchronize all PCM frames, to avoid congestion. Administrative network is to used to connect the remote operations and management centers to the nodes of the PSTN. All these four networks uses the channels in the basic transmission bearer network.
10/19/2012 TSSN 4ECE JNTUHCEH 9

Integrated Services Digital Network


Extension of IDN to provide wide variety of services to the customers premises. Something more(Supplementary services) than the services carried by PSTN. In PRI, less than 30 or 23 channels can be provided to obtain channels with greater digit rates for broad applications, as: H0 channel at 384 kbps. H11 channel at 1536 kbps(for 1.544 Mbps access. H12 channel at 1920 kbps(for 2.048 Mbps access).
4ECE JNTUHCEH 10

BRI standardized as ITU-T I.420 PRI standardized as ITU-T I.421

10/19/2012

TSSN

Integrated Services Digital Network

1. 2. 3. 4. 5. 6.

Standard interfaces between the user an d the network include functional units, as:
Exchange Termination(ET)End user connectivity. Line Termination (LT)---BRI or PRI access provisioning. Network Termination(NT1)-terminates access line at customers end. Network Termination(NT2)---enables switching functions to be performed. Terminal Equipment (TE1)provisioning of function required to handle layer 1, 2 & 3 protocols. Terminal Equipment(TE2)provides functions corresponding to capabilities of existing equipments which do not conform to ITU-T standards. Terminal Adapter (TA)converts layer 1,2&3 protocols of TE2 into those of TE1, to enable equipment on TE2 to operate over the ISDN.
11

7.

10/19/2012

TSSN

4ECE JNTUHCEH

Integrated Services Digital Network


Rapid connection setup and clear functionality of the switching system. supports both circuit switching and packet switching. supports point-to-point, multipoint and broadcast connections. Support variable data rates, message sizes and call holding times. CCITT SS7 protocol is used for interexchange signalling, using the D channel. Multimedia terminals.

10/19/2012

TSSN

4ECE JNTUHCEH

12

Cellular radio Networks


Trunked radio network Cellular radio network. Analog and Digital cellular standards. ANALOG STANDARDS
1. 2. 3. 4. 5. 6. 7. Advanced Mobile Telephone systems (AMPS) Nordic Mobile Telephone Service(NMT) Total Access Communication System(TACS) Network C Radiocom 2000 Nippon AMPS UNITAX,

1.

DIGITAL STANDARDS
DAMPS, GSM, CDMA, UMTS, LTE.

Periodic Registration and Handoff. Home Location Register and Visitor Location Register.
10/19/2012 TSSN 4ECE JNTUHCEH 13

Cellular Radio Networks


Digital transmission minimizes the inter-channel interference and enables closer channel spacing to be used. Cheaper alternative to cellular radio is tele-point or cordless service.

Another alternative: Personal communicator or Pager.

10/19/2012

TSSN

4ECE JNTUHCEH

14

Intelligent Networks
For addition of new services:
Electromechanical systems must deserve new hardware & modifications to all exchanges. SPC systems deserves software upgrade, in all the interconnected exchanges in the network (costly and time-consuming process).

SOLUTION: To separate software that controls basic functions, such


as call setup, supervising, etc.
Such a network is called INTELLIGENT NETWORK
10/19/2012 TSSN 4ECE JNTUHCEH 15

Intelligent Networks
SPC software is organized in 3 levels:
1. Node Software (provides common utilities
such as signalling, database access,..)

2.

Service Logic Programs (controls the


various services, using service independent
building blocks)

3.

Service Logic Execution Environment


(program execution environment that hosts

various SLPs and interworks with basic call


control and switching operations of the SSP )

10/19/2012

TSSN

4ECE JNTUHCEH

16

Private Networks
Required for organizations that deserve huge or frequent transmissions between its offices placed at various geographic areas. In PSTN, voice networks links to PBXs (Voice transmission) WAN links to their LANs (data transmission) Integrated services PBXs enables both voice and data transmission using same circuits. Virtual Private Network----encapsulation of a packet in another packet.-----secure transmission also.

10/19/2012

TSSN

4ECE JNTUHCEH

17

Numbering
National Numbering scheme
10 or 11 digits (area code, exchange code, customers no. on local exchange)

International Numbering Scheme


14 digits (Country code, National Number)

ISDN numbering plan


15 digits (Network Destination code(6), Customer address(9))

Public Data Network


14 digits (Data network identification code(4), Network Terminal Number(10))

10/19/2012

TSSN

4ECE JNTUHCEH

18

Charging Plan
Charging based on:
Initial charge for installing the customers line Annual rental or leasing charge Call charge

Charging mechanism
1. Flat-rate tariff 2. Message-rate charging
a. Metering based charging (bulk billing) b. Ticketing based charging (itemized billing)
10/19/2012 TSSN 4ECE JNTUHCEH 19

Routing Plan
Depends on:

No. and location of tandem switching centers No. of levels of tandem switching to be used in the network. Automatic Alternative routing , condition when to use it. (high usage routing or final routing) How many exchanges should be interconnected by direct circuits, and how many connected indirectly using tandem switching centers.

AUTOMATIC ALTERING ROUTING


Switching between High usage routes and the final routes to achieve the deserved grade of service, in overflow conditions

Overflow control
10/19/2012 TSSN 4ECE JNTUHCEH 20

Network Management
1. Management to public and private telecom networks is carried out in 4 levels as: Business level-includes sales, customer administration, billing, accounting, inventory control and investment planning. 2. 3. Service level-includes both basic services(telephony) and value added services. Network level- includes route optimization, traffic management, contingency planning to cope with emergencies, planning of changes and extensions to the network. 4. Network element level- includes installation of equipment, diagnosis of faults, maintenance management, repairs and alteration.

All the management aspects were performed using associated software. Network Management between various proprietary and non- proprietary networks resulted in the evolution of various STANDARDS.

10/19/2012

TSSN

4ECE JNTUHCEH

21

References
J E Flood, Telecommunication switching traffic and networks Pearson education, ISBN: 9788131705025. Theorode Rappaport, Wireless communications-Principles and Practice, Pearson publications. B Farouzan, Data Communications and Networking, TMH.

10/19/2012

TSSN

4ECE JNTUHCEH

22

You might also like