Scribd
Upload
154 views

Assignment 1 EP

This document is an assignment from the Faculty of Mechanical and Manufacturing Engineering at Universiti Tun Hussein Onn Malaysia for the course Mechanical Engineering Practice II. The assignment asks students to summarize the advantages and limitations of electro-pneumatic systems, draw and label the symbols for various electro-pneumatic components and indicate their applications, and design pneumatic and electrical circuits to control the extension and retraction of a cylinder based on inputs from three push buttons.

Uploaded by

saliana binti sanusi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
154 views

Assignment 1 EP

This document is an assignment from the Faculty of Mechanical and Manufacturing Engineering at Universiti Tun Hussein Onn Malaysia for the course Mechanical Engineering Practice II. The assignment asks students to summarize the advantages and limitations of electro-pneumatic systems, draw and label the symbols for various electro-pneumatic components and indicate their applications, and design pneumatic and electrical circuits to control the extension and retraction of a cylinder based on inputs from three push buttons.

Uploaded by

saliana binti sanusi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

UNIVERSITI TUN HUSSEIN ONN MALAYSIA

86400 Parit Raja, Batu Pahat, Johor Darul Ta’zim. http://www.uthm.edu.my

Fakulti Kejuruteraan Mekanikal dan Pembuatan

MECHANICAL ENGINEERING PRACTICE II (BDA 1811)

Assignment 1

1. What are the advantages and limitations of electro-pneumatic system?

2. With the aid of sketches, draw the symbols for electro-pneumatic components and
indicates its practical applications in a manufacturing industry.

 3/2 way single solenoid DCV


 Inductive sensor
 YES gate
 AC power supply
 5/2 way double solenoid DCV

3. A cylinder is used to transfer parts from a magazine. If either a pushbutton A or a


push button B is operated, the cylinder has to extend. Once the cylinder is fully
extended, it is to retract to the initial position by means of pushbutton C. Draw the
pneumatic and electrical circuits.

Submission date: Before/on Tuesday, 11th August 2009

ally2009

You might also like