Scribd
Upload
257 views1 page

As01 PDF

The document discusses four problems involving plane stress and strain. Problem 2.2 asks to determine coefficients for an Airy stress function for a cantilever beam under end load. Problem 2.3 examines a stress function for a cantilever beam in plane strain and verifies it satisfies boundary conditions except for a non-zero direct stress at the free end. Problem 2.4 describes a thin rectangular plate with a linearly varying edge load.

Uploaded by

Ashutosh Kumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
257 views1 page

As01 PDF

The document discusses four problems involving plane stress and strain. Problem 2.2 asks to determine coefficients for an Airy stress function for a cantilever beam under end load. Problem 2.3 examines a stress function for a cantilever beam in plane strain and verifies it satisfies boundary conditions except for a non-zero direct stress at the free end. Problem 2.4 describes a thin rectangular plate with a linearly varying edge load.

Uploaded by

Ashutosh Kumar
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Problems

61

Fig. P.2.2

as an Airy stress function and determine the coefcients A, B, and C . Ans. A = 2Pl /td 3 , B = 2P/td 3 , C = 3P/2td . P.2.3 The cantilever beam shown in Fig. P.2.3 is in a state of plane strain and is rigidly supported at x = L . Examine the following stress function in relation to this problem: = w 15h2 x 2 y 5x 2 y3 2h2 y3 + y5 20h3

Fig. P.2.3

Show that the stresses acting on the boundaries satisfy the conditions except for a distributed direct stress at the free end of the beam which exerts no resultant force or bending moment. Ans. The stress function satises the biharmonic equation: At y = h, y = w, and xy = 0, boundary conditions satised. At y = h, y = w, and xy = 0, boundary conditions satised. Direct stress at free end of beam is not zero, and there is no resultant force or bending moment at the free end. P.2.4 A thin rectangular plate of unit thickness (Fig. P.2.4) is loaded along the edge y = +d by a linearly varying distributed load of intensity w = px with corresponding equilibrating shears along the vertical edges at x = 0 and l.

You might also like