Scribd
Upload
38 views3 pages

Decoder User Manual: Step 1: Rightclick To Choose Netservice When Preview, See Below Pic

This document provides a 3 step process for configuring a decoder: 1) Right click to select Netservice and preview connection options, 2) Double click "Decoder" and enter the IP address, TCP port, username, password, and channel number of the device to decode, and 3) Click OK to reboot the decoder and apply the new settings. Pictures are provided to illustrate each step.

Uploaded by

rudy019
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
38 views3 pages

Decoder User Manual: Step 1: Rightclick To Choose Netservice When Preview, See Below Pic

This document provides a 3 step process for configuring a decoder: 1) Right click to select Netservice and preview connection options, 2) Double click "Decoder" and enter the IP address, TCP port, username, password, and channel number of the device to decode, and 3) Click OK to reboot the decoder and apply the new settings. Pictures are provided to illustrate each step.

Uploaded by

rudy019
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

DECODER USER MANUAL

Step 1: Rightclick to choose Netservice when preview,see below pic:

Pic 1

Pic 2 Step 2: Double "Decoder" to go into decoder setting,see below pic:

Pic 3 Channel(in red frame): channel number of decoder Enable: enable the decoder function HostIP: IP address of the device which you want to decode,both WAN and LAN are OK TCP: TCP port of the device which you want to decode User name: user name of the device which you want to decode Password: password of the device which you want to decode Channel: chanenl number of the device which you want to decode After you set it,chick Save,see below Pic.

Pic 4 Step 3: In Pic 4,click OK to reboot the decoder,see below pic: Note: Everytime you set decoder to effect it. the "decode" option, need to reboot the

Pic 5

You might also like