Scribd
Upload
205 views

Multicast Lab

The document provides instructions to configure PIM Dense Mode routing in an OSPF domain to allow multicast traffic from SW1 to be received by SW2. The key steps are: 1. Configure PIM Dense Mode on all interfaces between routers R1-R6 and connections to SW1 and SW2. 2. Enable IP multicast routing and OSPF area 0 throughout the network. 3. Verify multicast traffic can be received between SW1 and SW2 by using debug and show commands.

Uploaded by

Triệu Hồng Biên
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
205 views

Multicast Lab

The document provides instructions to configure PIM Dense Mode routing in an OSPF domain to allow multicast traffic from SW1 to be received by SW2. The key steps are: 1. Configure PIM Dense Mode on all interfaces between routers R1-R6 and connections to SW1 and SW2. 2. Enable IP multicast routing and OSPF area 0 throughout the network. 3. Verify multicast traffic can be received between SW1 and SW2 by using debug and show commands.

Uploaded by

Triệu Hồng Biên
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 5

PIM Dense Mode

Objective: Configure PIM Dense Mode throughout the OSPF domain so multicast traffic sent from SW1 can be received by SW2.

Directions
Command lists: R(config)#Ip multicast-routing R(config-if)#ip pim dense-mode R#Show ip pim neighbor Configure the logical topology per the diagram Configure Loopback interfaces on all devices in the format 150.1.Y.Y/32 Configure OSPF area 0 on all interfaces throughout the network Enable IP Multicast-Routing on R1, R2, R3, R4, R5, and R6 Configure PIM Dense-Mode on all transit interfaces between R1, R2, R3, R4, R5, & R6, and on R3 & R6s connections to SW1 and SW2 Ensure that multicast traffic originated by SW1 can be received by SW2

Show ip mroute Debpug ip pim R(config-if)#ip mroute-cache Note: turn-off fast switching thi moi debug duoc router xu ly goi tin. R#debug ip mpacket Show ip rpf a.b.c.d

Multicast RPF Failure


Objective: Configure PIM Dense Mode throughout the OSPF domain except on the link
between R1 and R5. Configure static multicast routes so that multicast traffic sent from SW1 can be received by SW2. Configure PIM Dense-Mode on all transit interfaces between R1, R2, R3, R4, R5, & R6 except the link between R1 and R5 Enable PIM Dense-Mode on R3 & R6s connections to SW1 and SW2 Configure a static multicast route on R4 so that traffic from 10.1.37.0/24 can be received via R2 Configure a static multicast route on R5 so that traffic from 10.1.37.0/24 can be received via R4 Command lists: R(config)#Ip mroute a.b.c.d subnet next-hop a.b.c.d subnet --- > source

You might also like