Scribd
Upload
195 views1 page

Pneumatics W1

This document provides the objectives and a task for a pneumatic practice course at Universiti Tun Hussein Onn Malaysia. The objectives are for students to learn to draw, install, and test basic pneumatic circuits to move actuators, identify pneumatic components, and create serial and parallel circuits. The task involves designing pneumatic control circuits using specified components to operate cylinders based on pressing switches under different conditions.

Uploaded by

saliana binti sanusi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
195 views1 page

Pneumatics W1

This document provides the objectives and a task for a pneumatic practice course at Universiti Tun Hussein Onn Malaysia. The objectives are for students to learn to draw, install, and test basic pneumatic circuits to move actuators, identify pneumatic components, and create serial and parallel circuits. The task involves designing pneumatic control circuits using specified components to operate cylinders based on pressing switches under different conditions.

Uploaded by

saliana binti sanusi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

UNIVERSITI TUN HUSSEIN ONN MALAYSIA

86400 Parit Raja, Batu Pahat, Johor Darul Ta’zim. http://www.uthm.edu.my

Fakulti Kejuruteraan Mekanikal dan Pembuatan

AMALAN TEKNOLOGI PEMBUATAN II (DDD 1023)

Title : Pneumatic Practice I

Objectives : Upon completing this task, students should be able to :


a) Draw a basic pneumatic circuit, install and test run it to move an
actuator.
b) Identify and operate a few types of pneumatic components.
c) Install the serial and parallel circuits for OR/ AND functions.

Task :

Design a pneumatic control circuit for the following operations. For each question, name
the related pneumatics components involved.
a) Presses switch A to extend a cylinder piston and press switch B to retract it.
b) Press either switch A or B will extend a cylinder piston. Then, it will be
automatically retracted when touching a limit switch.
c) Press switch A and B will extend a cylinder piston. It will be retracted if switch C
is pressed.

*Use a 5/2 way DCV double pilots.

You might also like