Scribd
Upload
3K views3 pages

Digital Voltmeter Using Icl7107

The circuit uses the ICL7107 analog to digital converter IC to build a 3.5 digit digital voltmeter with LED display that can measure DC voltages from 0-1999 volts. The ICL7107 integrates an ADC, comparator, clock, decoder, and seven segment LED display driver into a single chip. It allows for accurate voltage measurement with low power consumption of less than 10mW.

Uploaded by

syed_hafeez_2
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
3K views3 pages

Digital Voltmeter Using Icl7107

The circuit uses the ICL7107 analog to digital converter IC to build a 3.5 digit digital voltmeter with LED display that can measure DC voltages from 0-1999 volts. The ICL7107 integrates an ADC, comparator, clock, decoder, and seven segment LED display driver into a single chip. It allows for accurate voltage measurement with low power consumption of less than 10mW.

Uploaded by

syed_hafeez_2
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

DIGITAL VOLTMETER USING ICL7107

The circuit given here is of a very useful and accurate digital voltmeter with LED display using the ICL7107 from Intersil. The ICL7107 is a high performance, low power, 3.5 digit analog to digital converter. The IC includes internal circuitry for seven segment decoders, display drivers, reference voltage source and a clock. The power dissipation is less than 10mW and the display stability is very high. It has been designed as a panel meter and can be used in DC power supplies or anywhere else it is necessary to have an accurate indication of the voltage present. The circuit employs the ADC (Analogue to Digital Converter) I.C. CL7107 made by INTERSIL. This IC incorporates in a 40 pin case all the circuitry necessary to convert an analogue signal to digital and can drive a series of four seven segment LED displays directly. The circuits built into the IC are an analogue to digital converter, a comparator, a clock, a decoder and a seven segment LED display driver. The circuit as it is described here can display any DC voltage in the range of 0-1999 Volts.

CIRCUIT DIAGRAM

PARTS LIST
R1 = 180k P1 = 20k trimmer multi turn R2 = 22k U1 = ICL 7107 R3 = 12k LD1,2,3,4 = MAN 6960 common anode led displays R4 = 1M R5 = 470k R6 = 560 Ohm C1 = 100pF C2, C6, C7 = 100nF C3 = 47nF C4 = 10nF C5 = 220nF

PCB

You might also like