Scribd
Upload
144 views1 page

Loudspeaker Microphone Circuit

This circuit allows an ordinary loudspeaker to be used as a microphone. It uses two transistor stages - a common base stage to match the speaker's low impedance, and an emitter follower for a low output impedance. Sound waves moving the speaker cone produce a small voltage that is amplified before being able to drive longer cables. While speech quality is not as good as a dedicated microphone, acceptable results can be obtained from speakers between 1-3 inches in diameter with impedances of 4-64 ohms.

Uploaded by

gcbilal
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
144 views1 page

Loudspeaker Microphone Circuit

This circuit allows an ordinary loudspeaker to be used as a microphone. It uses two transistor stages - a common base stage to match the speaker's low impedance, and an emitter follower for a low output impedance. Sound waves moving the speaker cone produce a small voltage that is amplified before being able to drive longer cables. While speech quality is not as good as a dedicated microphone, acceptable results can be obtained from speakers between 1-3 inches in diameter with impedances of 4-64 ohms.

Uploaded by

gcbilal
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Loudspeaker Microphone Circuit Page 1

Loudspeaker
Microphone Circuit

Home Analysis Help Media Links Practical Schematics Simulation


Updates

Circuit : Andy Collinson


Email me

Description:
This circuit takes an ordinary loudspeaker and allows it to be used in reverse, as a microphone.

Notes
This circuits allows you to use a cheap loudspeaker as a microphone.Sound waves reaching the
speaker cone cause fluctuations in the voice coil. The voice coil moving in the speakers magnetic
field will produce a small electrical signal . The circuit is designed to be used with an operating
voltage between 6 and 12 volts dc. The first transistor operates in common base mode. This has
the advantage of matching the low input impedance of the speaker to the common base stage, and
secondly has a high voltage gain. The second stage is direct coupled and operates in emitter
follower. Voltage gain is slightly less than unity, but output impedance is low, and will drive long
cables.

Speech quality is not as good compared to an ordinary or ECM microphone, but quite acceptable
results can be obtained. Speaker cones with diameters of 1 inch to 3 inches may be used. Speaker
impedance may be 4 ohm to 64 ohm. The 8.2 ohm resistor value may be changed to match the
actual speakers own impedance.

Circuit Exchange Return to Miscellaneous http://


International www.zen22142.zen.co.uk
Circuits

http://www.zen22142.zen.co.uk/Circuits/Misc/Sp-mic.htm 21/06/2009 12:38:58

You might also like