Scribd
Upload
22 views6 pages

Lab 1 Graphs

This lab aimed to familiarize students with LabView and its filters. Students simulated a signal with three frequencies and amplitudes, summed the signals, and filtered the combined signal using low-pass and high-pass filters. Graphs were generated comparing the filtered and unfiltered signals, including a low-pass filtered signal below 50 Hz and two high-pass filtered signals above 500 Hz.

Uploaded by

dropped95si
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
22 views6 pages

Lab 1 Graphs

This lab aimed to familiarize students with LabView and its filters. Students simulated a signal with three frequencies and amplitudes, summed the signals, and filtered the combined signal using low-pass and high-pass filters. Graphs were generated comparing the filtered and unfiltered signals, including a low-pass filtered signal below 50 Hz and two high-pass filtered signals above 500 Hz.

Uploaded by

dropped95si
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 6

LabView Filters The purpose of this lab is to get familiar with labview, and labview filters, and diagrams.

In this lab we simulated the signal, with 3 different frequencies and amplitudes, then we took those signals and added them together to get a new signal , which is the sum of all three, then we run the summed signal to the filter, then we added a graph of the filteres and unfiltered signals ,

Fitered/ unfiltered Signals graphs :

This is the filtered signal that we obtained.

Low-pass filter with cut-off frequency near 50 Htz.

High-Pass filter with cu off frequencys near 500 Htz.:

High-Pass filter with cu off frequencys near 500 Htz.:

You might also like