Scribd
Upload
49 views1 page

Analog & Digital Circuits

This document is an exam for a third semester BE (Mechatronics) degree course on Analog and Digital Circuits. It contains instructions for candidates to answer any five of the questions from the exam. The exam consists of six questions with subparts on topics relating to digital and analog circuits including number systems, logic gates, flip-flops, counters, amplifiers, and oscillators. Students are asked to derive equations, explain concepts, and design circuits.

Uploaded by

Akhil Gupta
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views1 page

Analog & Digital Circuits

This document is an exam for a third semester BE (Mechatronics) degree course on Analog and Digital Circuits. It contains instructions for candidates to answer any five of the questions from the exam. The exam consists of six questions with subparts on topics relating to digital and analog circuits including number systems, logic gates, flip-flops, counters, amplifiers, and oscillators. Students are asked to derive equations, explain concepts, and design circuits.

Uploaded by

Akhil Gupta
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Reg. No.

MANIPAL INSTITUTE OF TECHNOLOGY


Manipal University
THIRD SEMESTER BE (MECHATRONICS) DEGREE END SEMESTER EXAMINATION NOV/DEC -2008 SUBJECT: ANALOG & DIGITAL CIRCUITS (ECE-221) TIME: 3 HOURS MAX. MARKS: 50

Instructions to candidates Answer any FIVE complete questions. Missing data may be suitably assumed.

1A. Convert the following: (i) (367.52)8 to its equivalent decimal and binary. (ii) 1001010 (Gray) to its equivalent binary code. 1B. Add the Excess-3 numbers 247.6 and 357.4 1C. Design a Binary to Gray code converter. Write a brief note on the codes. 2A. Implement a Full Subractor using a Demultiplexer. 2B. Explain an 8 to 3 Encoder with the truth table and logic diagram. 2C. Explain a Negative Edge Triggered S-R Flip Flop with the help of a timing diagram, truth table and internal circuit diagram. (3+2+5) 3A. Design a 3-bit Synchronous Down Counter using J-K Flip-Flop. 3B. Explain the Effect of Negative Feedback on Bandwidth of an amplifier. (5+5) (2+3+5)

4A. Derive the output equation of an Op-Amp as an Integrator and a Differentiator with waveforms. 4B. Explain the working of a Monostable Multivibrator with a block diagram and waveforms. (5+5) 5A. Explain a Voltage to Current Converter using Op-Amp. 5B. Derive expressions for voltage gain, current gain, input resistance and output resistance of an amplifier in terms of h-parameters. (5+5) 6A. Explain the working of a Crystal Oscillator. Derive the expression for reactance of the Oscillator and draw necessary waveforms. 6B. Convert (i) D Flip-Flop to J-K Flip-Flop
ECE-221

(ii) SR Flip-Flop to T Flip-Flop

(5+5)
Page 1 of 1

You might also like