Scribd
Upload
198 views

Code 193

The document describes a problem where one system requires VxSS authentication for a NetBackup connection, but the other system is not configured to use VxSS. This results in a status code 193 error terminating the connection. The recommended solution is to configure both systems to either use or not use VxSS authentication consistently based on their Use VxSS Host properties settings.

Uploaded by

subhrajitm47
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
198 views

Code 193

The document describes a problem where one system requires VxSS authentication for a NetBackup connection, but the other system is not configured to use VxSS. This results in a status code 193 error terminating the connection. The recommended solution is to configure both systems to either use or not use VxSS authentication consistently based on their Use VxSS Host properties settings.

Uploaded by

subhrajitm47
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Problem

NetBackup status code 193: VxSS authentication is requested but not allowed

Solution
Message: VxSS authentication is requested but not allowed Explanation: On one side of a NetBackup network connection, the system requires VxSS authentication. The system on the other side of the connection is not configured to use VxSS. VxSS authentication is used with the NetBackup Access Control feature (NBAC). The connection has been terminated because VxSS authentication cannot be completed. Recommended action: Make sure both systems are configured to use NetBackup Access Control VxSS authentication with each other. Or, make sure both systems are not configured to use VxSS with each other. The first thing to check is the Use VxSS Host properties value on each system. If one is configured for REQUIRED, the other must be configured for REQUIRED or AUTOMATIC. If one is configured for PROHIBITED, the other must be configured for PROHIBITED or AUTOMATIC. See the NetBackup Administrator's Guide, Volume I, for the following information: how to set the Access Control related host properties how to configure a system to use Access Control.

You might also like