Scribd
Upload
1K views1 page

ASTM C881 Summary

The document discusses ASTM C881, a specification that defines a classification system for epoxy resins used in civil engineering projects. It outlines seven types of epoxy systems based on application and properties like strength and viscosity. Each type has three grades based on viscosity and three classes based on operating temperature range. Epoxy Chemicals provides curing agents used to formulate common epoxy types, grades, and classes for civil applications defined in ASTM C881.

Uploaded by

Rodrigo García
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views1 page

ASTM C881 Summary

The document discusses ASTM C881, a specification that defines a classification system for epoxy resins used in civil engineering projects. It outlines seven types of epoxy systems based on application and properties like strength and viscosity. Each type has three grades based on viscosity and three classes based on operating temperature range. Epoxy Chemicals provides curing agents used to formulate common epoxy types, grades, and classes for civil applications defined in ASTM C881.

Uploaded by

Rodrigo García
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ASTM C881 Adhesives

Epoxy Resin Systems for Civil Engineering Applications

ASTM C881
Standard Specification for Epoxy-Resin Based Bonding Systems for Concrete Replace or Repair? A restoration project properly executed and using the correct repair products can add years to the service life of a structure. The cost to properly repair a structure is often significantly less than the cost of replacement or further deterioration. However, a poorly designed repair project using the wrong products can result in a continuing, expensive headache. The American Society for Testing and Materials developed ASTM C881 to assist engineers, architects and contractors select resin systems best suited for a particular application. This specification defines a classification system for epoxy resins and is routinely referenced in civil engineering projects. Seven Types are listed, based on application and physical properties such as compressive strength, modulus and bond strength. For each Type of epoxy system, the specification describes three Grades according to viscosity and sag resistance. Grade 1: Low Viscosity (2,000 cps max.) Grade 2: Medium Viscosity (2,000 10,000 cps) Grade 3: Non-Sag (1/4 sag resistance) The epoxy systems are further characterized by Class, which indicates the temperature range in which the epoxy can be applied. As an example, Class A products are designed for use below 40 degrees F., Class B products are for use between 40-60 degrees F., and Class C products are for use above 60 degrees F. Epoxy Chemicals, Inc. provides epoxy curing agents used to formulate the Types, Grades and Classes commonly used in civil engineering applications.

Epoxy Chemicals amine curing agents, A-6 Polyamine, FB-31 Polyamine, and FS-290 Polyamine, are used in the formulation of the following ASTM C881 epoxies:
Type I Bonding hardened concrete to hardened concrete (non-load bearing). Type II Bonding fresh concrete to hardened concrete (non-load bearing) Type III Bonding skid resistant materials to hardened concrete (low modulus) Type IV Bonding hardened concrete to hardened concrete (load bearing) Type V Bonding fresh concrete to hardened concrete (load bearing) Type VI Bonding and sealing segmental pre-cast elements with internal tendons and span by span erection. Type VII Sealing segmental pre-cast elements.

You might also like