R09-Cmos Analog and Mixed Signal Design
R09-Cmos Analog and Mixed Signal Design
R09-Cmos Analog and Mixed Signal Design
TECH II - SEMESTER EXAMINATIONS, APRIL/MAY-2012 CMOS ANALOG AND MIXED SIGNAL DESIGN
(DIGITAL SYSTEMS AND COMPUTER ELECTRONICS)
www.jwjobs.net
R09
Time: 3hours
1.a) b)
Max. Marks: 60 Answer any five questions All questions carry equal marks --Draw a standard cascode current sink circuit and explain its operation and output characteristics. Calculate the temperature coefficient of the Threshold referenced circuit, = 20 , VDD = 5V and R = 100k. Assume the other required values. where W L1 Resistor R is Polysilicon and has a temperature coefficient of 1500 ppm/0C, = 2.3 x 10-3V/0C.
( )
2.a)
Show that the sensitivity of the reference circuit shown in the figure is unity.
b) 3.a) b)
Draw a neat current sink inverter circuit and explain the operation. If W1 = 2m, L1 = 1m, W2 = 1m, L2 = 1m, VDD = 5V, VGG1 = 3V for a CMOS current sink inverter circuit having two transistors M1 and M2. Calculate outputswing limits. Draw the four feed back topologies and derive the expression for feedback factor and show the effect of feedback on voltage gain in all the 4 topologies. Design an op-amp with ideal op-amp characteristics. Explain the steps, conditions and requirements to design an op-amp. Explain the principle of Miller Compensation of two stage op-amp How can we improve the performance of open-loop comparator? Explain the function of switched capacitor voltage amplifier using the parallel resistor emulation. Write a brief note on: Mixed signal layout ADC architecture (any one has to be discussed) ****** www.jntuworld.com
4. 5. 6.a) b) 7. 8. a) b)
T N
W U
R O
D L