Scribd
Upload
96 views1 page

The Elements Used in The Circuit: R1 250 Ohm R2,3 50 Ohm R4,5 100 Ohm Led

A simple LED circuit uses resistors to reduce the current flowing through the LEDs from a battery to safe levels for the LEDs and prevent damage or shortened lifespan. Resistors are connected in series with the LEDs so that when a switch is closed, current passes through the resistors first, lowering the current to the rated value needed by the LEDs. The circuit diagram shows how resistors are arranged with LEDs and a battery to regulate the current flow.

Uploaded by

Fikret Baz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
96 views1 page

The Elements Used in The Circuit: R1 250 Ohm R2,3 50 Ohm R4,5 100 Ohm Led

A simple LED circuit uses resistors to reduce the current flowing through the LEDs from a battery to safe levels for the LEDs and prevent damage or shortened lifespan. Resistors are connected in series with the LEDs so that when a switch is closed, current passes through the resistors first, lowering the current to the rated value needed by the LEDs. The circuit diagram shows how resistors are arranged with LEDs and a battery to regulate the current flow.

Uploaded by

Fikret Baz
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Led Diode circuits could build a simple circuit of this project, we will explore adding resistance.

The reason we add resistance to a circuit, which is necessary for the operation of LEDs used in the circuit to reach the current value. If we connect directly to a 9V battery supply Diode the current in excess of the value of work to implement, Diode, lights up, also shortens the life of even lit. Immutable attribute this to all electronic devices. If we look at our circuit. LED diode circuit commissioning resistors connected as simple as it seems established, the LED current value decreased from.

Schematic representation of the summing circuit, as shown in the diagram above, the switch is closed when the current through the resistor to go through the first current value will be reduced and will be reduced to the value of LED diodes work.

The elements used in the circuit


R1 = 250 ohm R2,3 = 50 ohm R4,5 = 100 ohm Led

Battery

You might also like