Scribd
Upload
127 views

G75 First CNC Programming Block: N10 G75 R N20 G75 X Z P Q R

The document explains the parameters of a Fanuc G75 grooving cycle for CNC programming. The G75 cycle uses parameters including R for return amount, X for groove depth, Z for last groove position, P for peck increment in X-axis defining the depth of each cut, and Q for stepping in Z-axis, with R specifying the relief amount at the end of the cut. A peck is also defined as a drilling operation that periodically retracts the tool to clear chips or flood the hole with coolant.

Uploaded by

Sriharsha Pidaparthi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
127 views

G75 First CNC Programming Block: N10 G75 R N20 G75 X Z P Q R

The document explains the parameters of a Fanuc G75 grooving cycle for CNC programming. The G75 cycle uses parameters including R for return amount, X for groove depth, Z for last groove position, P for peck increment in X-axis defining the depth of each cut, and Q for stepping in Z-axis, with R specifying the relief amount at the end of the cut. A peck is also defined as a drilling operation that periodically retracts the tool to clear chips or flood the hole with coolant.

Uploaded by

Sriharsha Pidaparthi
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Not very difficult to program just few parameters are required.

Here is explanation of all the parameters of Fanuc G75 Grooving Cycle


N10 G75 R N20 G75 X Z P Q R

G75 First CNC Programming Block


R Return amount

G75 Second CNC Programming Block


X Groove Depth (Groove end position in x-axis) Z Last groove position in z-axis (End Position in z-axis) P *Peck increment in x-axis (depth of each cut in x-axis) Q Stepping in z-axis. R = Relief amount at end of the cut. *What is a Peck = A drilling operation that periodically retracts the tool to clear chips or flood the hole with coolant.

You might also like