Scribd
Upload
100 views1 page

Friction - SKF PDF

This document provides a table that lists various sliding contact surface combinations and their corresponding coefficient of friction ranges. The table shows that steel-on-steel and steel-on-bronze combinations have coefficients of friction between 0.08-0.2 and 0.1-0.25 respectively. Other combinations such as steel/PTFE fabric and steel/PTFE FRP have lower coefficients of friction ranging from 0.03-0.15 and 0.05-0.2 respectively.

Uploaded by

Dario Forestiere
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100 views1 page

Friction - SKF PDF

This document provides a table that lists various sliding contact surface combinations and their corresponding coefficient of friction ranges. The table shows that steel-on-steel and steel-on-bronze combinations have coefficients of friction between 0.08-0.2 and 0.1-0.25 respectively. Other combinations such as steel/PTFE fabric and steel/PTFE FRP have lower coefficients of friction ranging from 0.03-0.15 and 0.05-0.2 respectively.

Uploaded by

Dario Forestiere
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

G roup

P roducts

Bearings, units and housings

P lain bearings

G eneral

F riction

table 1 - Coefficients of friction for different sliding contact surface combinations (guideline values) Sliding contact surface combination Coefficient of friction min Steel-on-steel Steel-on-bronze Steel/sintered bronze composite Steel/PTFE fabric Steel/PTFE FRP 0,08 0,10 0,05 0,03 0,05 max 0,20 0,25 0,25 0,15 0,20

You might also like