Scribd
Upload
15 views2 pages

DATACOM Multiple Choice Question 13

DATACOM Multiple Choice Question

Uploaded by

girijamohapatra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
15 views2 pages

DATACOM Multiple Choice Question 13

DATACOM Multiple Choice Question

Uploaded by

girijamohapatra
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

1.

The most widely used data code ASCII consists of 8 bits of which 7 are ______________bits and one ______________ bit.

True/False
1. Half Duplex Transmission is two way Simultaneous Communication 2. The problem of synchronization is solved in NRZ codes which ensure sufficient transitions in the data signal.

3. In the analog transmission of digital data, the baud rate is less than or equal to the bit rate. 4. The Nyquist theorem states that a signal must be sampled at a rate greater than twice the lowest frequency component of the signal to accurately reconstruct the waveform. 5. Multiplexing technique allows multiple users to share total capacity of a transmission medium. Short questions 1. An analog signal carries 4 bits per signal element. If 1000 signal elements are sent per second, find the bit rate and baud rate. 2. Calculate the maximum data rate permissible for transmission if the B.W. of a channel is 300-3400 Hz and S/N ratio is 127. 3. Calculate the number of levels required for transmission if the B.W. of a channel is 300-3300 Hz and data rate is 24kbps.
I. Answer the following questions.

1.What is ARQ? (Automatic repeat request) 2. Name a routing protocol.(RIP) 3. What is DHCP?(Dynamic host configuration pr0t0col) 4. Write a class C private IP address.(200.12.22.123) 5. Expand CSMA / CD

II. Fill up the blanks 1. Decryption and encryption of data are the responsibility of the . layer.(Presentation) 2. Maximum segment length in case of 10base5 LAN will be.(500m)

3. When a secondary device is ready to send data, it must wait for frame.(Poll) 4. Router works in . layer of OSI model.(3)

You might also like