Bee - Cse - It
Bee - Cse - It
1. (a) Define terms with their units (i) magnetic circuit (ii) magnetic flux (iii) magnetic flux density (iv) MMF (iv) Reluctance (vi) Magnetic field strength (vii) permeability (b) Explain self inductance & mutual inductance 2. (a) differentiate the analogy between magnetic circuits and electric circuits (b) Explain types of magnetic circuits and describe any one of them in which procedure for amp turns calculation 3. (a) what is a parallel magnetic circuit explain how total AT calculated in it (b) Explain and draw magnetization characteristics of Ferromagnetic materials 4. (a) explain how to obtain B-H curve of a magnetic material. What does curve indicate (b) A steel magnetic circuit has a uniform C.S area of 4cm2 and a length of 50cm. A coil of 250 turns is wound uniformly over the magnetic circuit. When the current is 1.5 A, the total flux is 0.25 mwb, when the current is 5A, the total flux is 0.6mwb. For each value of current calculate (H) magnetic field strength (b) relative permeabitity of the steel 5. (a) what do you understandby terms Hysteresis loss and derive an expression for the same in a magnetic material (b) caluculate value of ysteresis loss in water Occuring magnetic material, when the flux density is 1.2 tesla, frequency variation is 40hz, volume of material is 400cm3. Take steminetz constant 1.6 6 (a) derive an expression for the energy stored in a magnetic field (b) the mean diameter of a steelring 40 cm and B = 0.8wb/m2 is produced by 50 AT/cm.if the C.S.area of the ring is 25cm2 and no.of turns is 800.find(1) the inductance in the coil (2) exciting current and inductance ,when airgap of 1 cm is cut in the ring. B=1wb/m2 7 (a)Two coils 1 & 2 having self inductances L1 &L2 henry respctly., and mutual inductance M are wound coaxially on an insulating cylinder.derive an expression for the total inductance when two coils are connected with fluxes in aiding position and opposing position (b) The combined inductance of two coils connected in series is 1.2 &0.2 H depending on the relative directions of the currents in the coil. if one of the coil when isolated has a self inductance of 0.4H calculate (i) M mutual inductance (ii) coupling coefficient k 8 (a). Write kirchoffs KCL and KVL in point form/magnetic circuit form (b) The air gap in a magnetic circuit is 1.5mm long and 2500mm2 in a C.S area. Calculate (i) reluctance of the gap (ii) mmf required to setup a flux of 800*10E-6 wb in airgap